Retainer for Roller Cam

fasttback · Nov 30, 2006

Doing the switch from flat tappet to a roller cam in my 68 302 block (352 stroker). I have already purchased roller lifters (for the older blocks) and a bronze dizzy gear.

I found this cam retainer with roller bearing or race that is suppose to be made for a roller cam. Is this any good (newbie to the roller cam stuff)? Should I just look for a steel retainer?

D.Hearne · Nov 30, 2006

Retainer with a roller bearings a good idea, as long as you don't have to do any machining. But I'd advise against that bronze gear. Get a steel one, it'll out last the bronze by a long shot.

fasttback · Dec 1, 2006

I prefer steel, but the bronze dizzy gear was a deal on eBay.

I always questioned the bronze gear (which I thought was a softer material), but I know they have been running these things since the 80's without any major issues. Should I be that concerned with a weekend cruiser?

65ShelbyClone · Dec 1, 2006

fasttback said:
Should I be that concerned with a weekend cruiser?

Maybe not, but you would do well to check both the gear and your oil once in a while to make sure it isn't going away. A steel gear will be maintainence free, though.

If it's just a fun car that doesn't get flogged at the track 50 weekeds a year, you should do just fine with the stock cam retainer plate. Like D. Hearne said, go with it if you can get one that doesn't need block machining. Otherwise, skip it.

I'm jealous that you have two fastbacks, BTW.

fasttback · Dec 2, 2006

65ShelbyClone said:
I'm jealous that you have two fastbacks, BTW.

Thanks. There far from "show" quality and require a lot of my time...but worth it.

Retainer for Roller Cam

fasttback

New Member

D.Hearne

New Member

fasttback

New Member

65ShelbyClone

fasttback

New Member

Similar threads

Retainer for Roller Cam

fasttback

New Member

D.Hearne

New Member

fasttback

New Member

65ShelbyClone

fasttback

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency