Romoving heads with roller rockers?

[IndyBlk5.0]

Removing heads with roller rockers?

removing my heads, i have crane roller rockers and i was wondering how i get the rods out by no taking off my rockers... is there two rods per rocker or what? the ones that go past the intake are visable becuase i ahve my lower off, is there another rod in the spring part? Tell me what to do, im taking these heads to a mach shop to have them flattened and valve job, and hot dipped. Thanks

 

[perkys stang]

Unbolt the rockers and the pushrods should come right out... I would just remove the rockers and set them to the side...

 

[1Stang2Go]

the machine shop is going to pull the rockers off anyway..If they are stock heads, they are ped mount and just bolt down. Its not a big deal. If you really didn't want to take them off, you might be able to loosen it enought to pitiv the rocker away from the pushrods.

 

[1Stang2Go]

one rod per rocker, two rockers per cylinder
the rod in the spring part is your valve. you need a compressor to pull the springs. Let the machine shop do that. Unless you have a spring compressor...

 

[IndyBlk5.0]

the problem is that these need hex nut tools to take them off, and when i found the right hex nut tool, it was so friggin tight i couldnt get off. i will go take some pictuers with my ghetto camera excuse the bad quality

 

[IndyBlk5.0]

so much for the camera idea, i cant find my credit card camera and my other one doesnt have any batterys