RPM throttle inlet too small for new tb

[jruppert]

I assumed the inlet would be smaller but I didnt realize it woudl be a lot smaller. I have a fox accufab 80mm with the spacer. I would say its a good 1/4 all the way around. Does anyone have any experience with this? I figured I would have to open it up but it looks as if I may not have room.

 

[Grn92LX]

Open it up best you can with a dremel. Just dont go to far where you break into the egr port.

 

[jruppert]

yeah i noticed it was going to be really close. i dont think it will work.