• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

running rich

  • Thread starter Thread starter 865.0trunk
  • Start date Start date Feb 1, 2006
8

865.0trunk

New Member
Dec 11, 2005
3
0
0
Canada
Feb 1, 2006
#1
  • Feb 1, 2006
  • #1
ok i have an 86 5.0 trunk. i converted this car from a 4 cylinder and put a full 88 dirvetrain in it. i put on long tube headers and a full flowmaster exhaust. the car is running and starting up fine, the problem is when i give it gas. if i put it to the floor it is very sluggish it takes about 1 second before it starts to rev up, and when it does it revs up slow. the motor has been sittin for a while but i have been running it.. when i rev it up it is very blue and smells really bad of unburned gas. i took it outside and put the pedal to the floor, on ice the car wouldnt even spin. i havent done a tune up on it yet, (plugs wires etc). have all the polution equipment removed. can someoen please help me.
also the long tube headers i put on, they come apart off the collector, and they are leaking a bit, the guy told me they will seal when they are bolted down, they dont seem to be sealing, could that be a problem, and the 02 sensor only goes into 1 primary tube. thanks guys i appreciate your help.
 

Strype

Cuthbert catcher
Founding Member
May 11, 1999
61
34
104
Huntsvegas, AL
Feb 1, 2006
#2
  • Feb 1, 2006
  • #2
Fuel pressure to high
Control module?

Sounds like more than an exhaust leak to me... Definately do a tune up and then go from there.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Feb 1, 2006
#3
  • Feb 1, 2006
  • #3
Dump the codes and see what the computer says is wrong…

Here's the link to dump the computer codes with only a jumper wire or paper clip and the check engine light, or test light or voltmeter. I’ve used it for years, and it works great.

See http://www.troublecodes.net/Ford/
OR
See http://www.mustangworks.com/articles/electronics/eec-iv_codes.html

IF your car is an 86-88 stang, you'll have to use the test lamp or voltmeter method. There is no functional check engine light on the 86-88's except possibly the Cali Mass Air cars.

Codes have different answers if the engine is running from the answers that it has when the engine isn't running. It helps a lot to know if you had the engine running when you ran the test.

Trouble codes are either 2 digit or 3 digit, there are no cars that use both 2 digit codes and 3 digit codes.

For those who are intimidated by all the wires & connections, see http://www.actron.com/product_detail.php?pid=16153 for what a typical hand scanner looks like. Normal retail price is about $30 or so at AutoZone or Walmart.

Or for a nicer scanner see http://www.midwayautosupply.com/detailedproductdescription.asp?3829 – It has a 3 digit LCD display so that you don’t have to count flashes or beeps.. Cost is $35.
 
You must log in or register to reply here.

Similar threads

J
i need help
  • JK.
  • Oct 24, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
22
Views
617
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 28, 2026
JD1964
J
Engine Running like crap :(
  • justadude07
  • Sep 27, 2025
  • Fox 5.0 Mustang Tech
Replies
8
Views
535
Fox 5.0 Mustang Tech Oct 19, 2025
DadLife0724
D
rpm goes up - car does not speed up.
  • dawakbar
  • Oct 26, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
148
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 27, 2026
nickyb
T
Resolved No run or idle
  • Thebluefox1
  • Oct 10, 2025
  • Fox 5.0 Mustang Tech
Replies
14
Views
654
Fox 5.0 Mustang Tech Nov 25, 2025
DadLife0724
A
Resolved 302 oil leak when running
  • AlexM556
  • Sep 8, 2026
  • Classic Mustang Specific Tech
  • 2
Replies
36
Views
1K
Classic Mustang Specific Tech Nov 1, 2026
manicmechanic007
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?