Serpentine Pulleys

Well, I have almost finished my serpentine swap on my mule motor for my fastback. I bought a late model crate engine for my 65 fastback until I finish my 347. I also converted over to the serpentine setup. I came to this site to get info on the swap and found lots of people looking to do the same. Well I set out to do this on a budget and I think I did a pretty good job . Here is my info in case somebody is out there trying to do the same thing. You can also email me at zay@whittz.com if you have any questions. Here is my parts list and pictures:
1. March -MCH-1465 Alt Bracket -$54.88 (Summit)
2. TFS 51500600 AC Delete $29.95 ( Summit)
3. Stock 87-93 Mustang 5.0 Tensioner
4. Stock 87-93 Mustang 5.0 Crank pulley
5. Stock 87-93 Mustang 5.0 water pump pulley
6. Stock 87-93 Mustang 5.0 Alt Pulley

All the stock mustang stuff can be had for cheap on ebay or the junkyard...
http://whittz.com/v-web/gallery/Engine Pictures of my project!!!

No problem, I am going to get abelt today and will post a update picture. I ran this setup on my 91 coupe for about 5 years with no problems...

Here is some updated pictures of the tension on the belt...


http://whittz.com/v-web/gallery/Engine?page=2

Your right!!! It all works well...