As of now, the car puts down 630rwhp/565rwtq. We saw 15psi at the top of the runs with a 3.5" upper and an 8" lower. I bought a smaller pulley(3.0") before my previous tune and the way things were going (power-wise) it would've been +/- 700rwhp and I would've maxed out my injectors. So I swapped the pulley to the 3.5" and went back and that's when the car put down the 630 number.
Anyways, lately I have been thinking about adding meth to the car and I'm not really sure what to do. The motor can take it. I already have the pulley and the right belt, I'd just have to buy the meth kit, upgrade to 83# injectors.
What would you do?
Leave it alone?
Swap to the 3.0" and spray meth pre-compressor?
Leave the 3.5" pulley and spray meth pre-compressor ontop of that? I'm not sure if the benefits would be worth the cost; if it would cool the charge anymore. i'm seeing intake temps in the 90* range with my air/air
Anyways, lately I have been thinking about adding meth to the car and I'm not really sure what to do. The motor can take it. I already have the pulley and the right belt, I'd just have to buy the meth kit, upgrade to 83# injectors.
What would you do?
Leave it alone?
Swap to the 3.0" and spray meth pre-compressor?
Leave the 3.5" pulley and spray meth pre-compressor ontop of that? I'm not sure if the benefits would be worth the cost; if it would cool the charge anymore. i'm seeing intake temps in the 90* range with my air/air