smog pump eliminator

[Farmers SN95]

I have a UPR smog pump eliminator and I have about 13,000 on it,
But now the bearing is going out.

So what kind of smog pump eliminator do you have?

 

[slow50sally]

No eliminator just run a shorter belt

 

[Dagz]

No kit just running a shorter belt with AC could get the lenth if you need it no troubles at all. Plus I'm cheap so whatever works!

 

[SeventyMach1]

I run the one that Summit sells. Nice quality. No problems yet.

 

[vp6799]

For the guys that run a shorter belt. Do you know what size to get?? What pieces have to be removed?? Is it just the pump and the piping that goes with it, what if any has to be blocked?


Thanks
Vic

 

[94GTStang]

I've had an ASP pulley for about 5 years now without any problems.

 

[SeventyMach1]

For the guys that run a shorter belt. Do you know what size to get?? What pieces have to be removed?? Is it just the pump and the piping that goes with it, what if any has to be blocked?


Thanks
Vic

I don't run a short belt .... but maybe this will help you ......

SMOG REMOVAL

BELT DIAGRAMS

 

[NotQuik]

I have the ebay special....suprisingly still in one piece and it's quiet.

 

[DaveB]

ASP. Been on 4 years without a problem.

 

[Dagz]

VP6799 take off the pump and lines, all I did to block the heads was take the stock piece that bolts up, cut the tube with a hack saw as close as you can get it then flip them over, and switch sides so the backs are now facing the heads, and run a little silicon on them and tighten it back up. belt lenth is 90''. Part number 5060900

That is with ac and no pullies. Hope that answers some questions

dagz

 

[93GTWannabe]

I'm just running a shorter belt. I deleted my AC and my Smog pump, MY belt size is 82". as for the associated equipment with the Smog pump, you can put a bolt in the back nof the heads to block it off, and you'll need a blockoff plate for the exhuast. I haven't actually removed my smog pump yet. I'm doing that after Deployment when i pull the motor and tranny in favor of the new ****.

 

[vp6799]

VP6799 take off the pump and lines, all I did to block the heads was take the stock piece that bolts up, cut the tube with a hack saw as close as you can get it then flip them over, and switch sides so the backs are now facing the heads, and run a little silicon on them and tighten it back up. belt lenth is 90''. Part number 5060900

That is with ac and no pullies. Hope that answers some questions

dagz

Awesome, thanks for the info. I'll try that this weekend.

Vic