sn95 spindles

86'4:10C-4

New Member
Aug 23, 2005
10
0
0
northglenn,Co
hi. i drive an 86 mustang gt and i am planning on changing my front spindles calipers and rotors to sn95 stuff. i know the ball joints are a little different...i was hoping to get some advice on how to go about doing the swap...and what i should do to get over some of the problems...anything helps...
 
Any sn-95 model spindles will work but you need the brake line screw that goes in to the caliper off the sn-95 because the threads are different on the fox body. If you use spindles off of a v-6 I'm told you need to use that strut also. Hope that helps!
 
Well, the best source for info is http://sn95brakes.com

You need a spacer for the ball joint or SN95 ball joints, and your struts have a wider opening than all of the SN95 spindles, v8 and v6. So you either need newer struts (87-93 V8 struts) or you need a spacer in between spindle and strut to fill the opening. Washers might work, but some struts come with metal spacers.

There are several other sites with more install info, but I don't have them marked on this PC. Do a search on brakes and you should find some.