speed density

pony gt

New Member
Mar 17, 2006
21
0
0
i just recently bought an 87 gt, it has pro topline heads with 2.1 " intake valves and 1.6" exhaust valves and a .560 lift cam in it.
it still has speed density and idles up and down 300-500 rpm and occasionally stalls when i push in the clutch. is there any way i can fix the idle problem without converting it to mass air or is that about my inly option.
 
You didn't say much about the cam profile but if it idles at all then I doubt that the cam is your problem. You need tostart looking around your engine bay and up under the dash for old, broken, cracked, and rotting vaccum lines. A spray can of starting fluid sparingly misted around the engine bay can help with this. Surging idle in not usually an indication of cam/list problems. Vac leaks, are.
 
i have already sprayed carb & choke cleaner over the engine looking for an intake leak or vacuum leaks and so far found nothing. the guy i bought it from said he thought it was cuz of o2 sensors but i thought it might be the computer, not being able to work with that cam and head set up
 
pony gt said:
the guy i bought it from said he thought it was cuz of o2 sensors but i thought it might be the computer, not being able to work with that cam and head set up

Surging idle symptoms are not indicitave of a problem with cam and heads. If you weren't getting enough vac from your cam (providing that was the only problem) you'd idel either high or low and your fuel maps would be off across the board.
 
well for now i turned my idle up to about 1000 and it runs smooter it doesnt surge near as much but i cant find a vac leak worth a damn!!!
:bang: oh and this is way off topic but i OWNED a z 28 today, i spanked it sooo bad he quit by middle of second