• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

starter starts...but won't stop!!! need a little help here...

  • Thread starter Thread starter mustanghunter50
  • Start date Start date Jul 11, 2006

mustanghunter50

New Member
May 30, 2006
123
0
0
easton pa
Jul 11, 2006
#1
  • Jul 11, 2006
  • #1
so i got my starter to work- somewhat- but when i put my battery cable on- the starter starts cranking without the key even being in the ignition. the car starts if i have the key turned all the way on, but the starter won't stop. what is wrong with it?
 
U

uneverkno

New Member
Aug 18, 2005
65
0
0
Jul 11, 2006
#2
  • Jul 11, 2006
  • #2
sounds like the solenoid is stuck on the starter, same thing happened to mine.
 

mustanghunter50

New Member
May 30, 2006
123
0
0
easton pa
Jul 11, 2006
#3
  • Jul 11, 2006
  • #3
ok, so what did u do about it? my selenoid is mounted on the fenderwall
 

jaymac

New Member
Feb 18, 2004
995
0
0
Northern Mass
Jul 11, 2006
#4
  • Jul 11, 2006
  • #4
A. Whack the solenoid 1/ a screwdriver, wrench, hammer, etc.,
or
B. Replace the solenoid.

Mine sticks every so oftern, so I have to get out of the car, open the hood and hit it w/ a pair of iers.
Pretty gay.
 

85ragtop

BTW, I like dudes.
10 Year Member
Nov 29, 1999
823
475
123
NC
Jul 11, 2006
#5
  • Jul 11, 2006
  • #5
Get a new solenoid. I went to an auto zone and got a heavy duty one.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jul 11, 2006
#6
  • Jul 11, 2006
  • #6
Attempting to start the car with a half dead battery can tack the starter relay contacts together (in case that's happened lately and you're lookin for a reason as to why this happened).

Good luck.
 

85ragtop

BTW, I like dudes.
10 Year Member
Nov 29, 1999
823
475
123
NC
Jul 11, 2006
#7
  • Jul 11, 2006
  • #7
I was having to get a new one like every other week. Then somone told me to add an extra ground. I did it and have not had a prob. in over a year.
 

LX93RiceKill

New Member
Jul 9, 2006
14
0
0
Jul 11, 2006
#8
  • Jul 11, 2006
  • #8
Also check the wires at the solenoid, make sure you hooked them all up right. But ya, most likely you need a new solenoid. I always carry a backup in my car. Ya never know.
 

jaymac

New Member
Feb 18, 2004
995
0
0
Northern Mass
Aug 24, 2006
#9
  • Aug 24, 2006
  • #9
I'm re-vamping this thread, even though I already answered a long time ago....
I've replaced my starter three times since. Sometimes it goes for a LONG time w/o sticking open. I replaced it the other day w a duralast HD, and the first three times it started, it stuck open. Replaced it that same day w/ another, and no problems the first three starts, but now it's almost every time. RIDICULOUS!!!!!!!!!
So what is it and why??? I'll try adding the extra ground, but seriously, W T F?!?!?!?!?!?!?!?!?!?!?!
It's so embarassing, walk out in the parking lot, and someone's admirirng your car, and they want to talk all about it, and then you get it to leave, and your starter's grinding it's little heart out and you have to pop your hood and run out of the car and smash it with a pair of pliers.
It's not attractive to the opposite sex.....
 

jaymac

New Member
Feb 18, 2004
995
0
0
Northern Mass
Aug 24, 2006
#10
  • Aug 24, 2006
  • #10
had to DP - I forgot to subscribe.....
 

Fett

New Member
Nov 2, 2004
766
6
0
Aug 24, 2006
#11
  • Aug 24, 2006
  • #11
You can avoid the "sticking solenoid" problem by upgrading to a 95 starter. Get a starter from a 95 5.0, it will bolt right in...and it is easier because it is a tad smaller. You will need to move the starter wire from the nearside post on the solenoid and move it to the + battery terminal. Then you will need to run a small gauge wire from the nearside solenoid post (where the starter wire used to be) down to the trigger post on the starter.

I fried a couple solenoids, which in turn fried the starters because they wouldn't stop sending power to it. I since switched to the 95 starter and have no problems what so ever. Plus the car starts a little quicker.
 

jaymac

New Member
Feb 18, 2004
995
0
0
Northern Mass
Aug 29, 2006
#12
  • Aug 29, 2006
  • #12
LX93RiceKill said:
Also check the wires at the solenoid, make sure you hooked them all up right. But ya, most likely you need a new solenoid. I always carry a backup in my car. Ya never know.
Click to expand...
OK, so today I had the problem again w/ a little bit of ECT issues and remote starter issues mixed in. Long story short, my NEGATIVE BATTERY CABLE CAUGHT FIRE AND MELTED THE WIRE RIGHT OFF THE TERMINAL.
not good.
My question about the quote is, when you say add anopther ground, are you talking about another ground to the battery/chassis? Cuz I had wanted to add a new ground anyway, mine was kinda crappy. I just hope I didn't short out the whole electrical system.
Could I have????
 
You must log in or register to reply here.

Similar threads

A
1987 5.0 speed density Foxbody crank no start
  • Alan2204
  • May 23, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
309
Fox 5.0 Mustang Tech May 30, 2026
Mcmahst
C
Electrical HELP! 1989 5.0 Stick, Voltage Bleed onto Ignition Trigger wire
  • ChickenDeluxe
  • May 14, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
234
Fox 5.0 Mustang Tech May 24, 2026
ChickenDeluxe
C
T
Electrical 1990 Vert starting/Solenoid issues
  • Tom77
  • Apr 18, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
385
Fox 5.0 Mustang Tech Apr 18, 2025
85GTStangGuy
8
Electrical Crank-no start ... no spark ... no injector pulse, was it something I did? (redux)
  • 85gtCOBRA
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
570
Fox 5.0 Mustang Tech Oct 29, 2025
85gtCOBRA
8
M
2004 v8 convertible
  • Mikeycrownvicluver
  • Feb 12, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
11
Views
368
1996 - 2004 SN95 Mustang -General/Talk- Feb 15, 2026
Mikeycrownvicluver
M
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?