Steeda Sport Springs

My car isn't finished, and it is a coupe, but still a fox body. KEEP IN MIND THE CAR IS NOT FULL WEIGHT.....I lack doors, interior, hood, bumper, and it is a 2001 2V engine, not a 302. These are Steeda Sport Springs. I have 96-04 front spindles, with stock fox body LCA's and struts.



View attachment 331625


The rear is not low at all. It is the 2001 axle, Steeda Sport Springs, and HPM Mega Bite Jrs LCA's. I have both spacers under the spring that HPM provides. I am going to take both of them out and use a stock rubber or poly isolator. The bottom part of the quarter panel is 29 inches off the ground. With spacers removed it will go down to 28-1/2" KEEP IN MIND THE CAR IS NOT FULL WEIGHT.....I lack doors, interior, fuel in the tank spare, jack, tail lights. I want to get it down to at least 27-1/2". My other notch sits at that height and I like it.

I have them in my LX Hatch but it's under a car cover, covered in snow at the moment. Expect to see a similar drop to those with FRPP B springs and no isolators. The front tires (ponys) are basically in line with the fenderwell and the rear fender is about 1" above the rear tire on my car. I used Isos all the way around. The ride is harsher than stock but not horrible. The car handles waaaay better.

i have them on my vert, i think i was told like 1 1/4 drop but saw more like 1 1/2.
they are stiff enough to make life fun but not so stiff that your kidneys bleed. i like em.

Steeda sport springs... on a notch tho...