If you have been reading my posts for the last week you know I have been working on a T-45 Swap.
I have finished mounting the T-45 on the motor and am installing the driveshaft.
I went to place the motor in Neutral and I can't get into/out of gear oir neutral!
No fluid....will I mess it up w/o fluid??? The motor is not on and the T-45 was sitting for months (dry)
Before installing it I made sure that it spun freely...but I did not row thru the gears (stupid I know)
I have a Steeda Tri-Axe shifer....In case that matters...
I have finished mounting the T-45 on the motor and am installing the driveshaft.
I went to place the motor in Neutral and I can't get into/out of gear oir neutral!
No fluid....will I mess it up w/o fluid??? The motor is not on and the T-45 was sitting for months (dry)
Before installing it I made sure that it spun freely...but I did not row thru the gears (stupid I know)
I have a Steeda Tri-Axe shifer....In case that matters...