subframe connector question

[68GEETEE]

I just bought a set of bolt-in subframe connectors, which I also plan to weld in for extra strength after they are installed. Does anyone here have any tips about installing these? Can i do the work using jackstands, or do I need to have the car on a lift? Any help is appreciated.

 

[Fostang]

No lift needed.

Just make sure your rear is supported properly as you may need to remove the front bolt of the lift spring to bolt them on.

 

[thehueypilot]

I installed a set of TCP sub-frame connectors on my 68. Welding is the strongest and best method. There is not enough thick metal in a mustang frame to bolt up to. I put the car up on four jack stands at the same height all the way around and tack welded the connectors on, double checked everything then welded the ends all the way around with a lot of heat on the stick welder. I drag race it often and it is holding up well. It has not helped my 60' times at all.

 

[diverdaveman]

Yeah, there easy to install. Just make sure your stang is stable in the air. I too welded mine in. Stronger and safer.

Dave

 

[68GEETEE]

THanks for the replies, with a little luck, I am going to install them this weekend.

 

[allcarfan]

If they are powdercoated or painted, make sure you grind off the coatings on the area you are going to be welding on BEFORE you bolt them on. It will make things a lot easier.