• Mustang Forums
  • 2005 - 2014 S-197 Mustang -General/Talk-
  • 2005 - 2009 Specific Tech

Success stories?

  • Thread starter Thread starter dhavi4226
  • Start date Start date Nov 26, 2005
D

dhavi4226

New Member
May 17, 2005
15
0
1
Nov 26, 2005
#1
  • Nov 26, 2005
  • #1
The 05' 06' clunking front and /or rear suspension. I read one post that refers to tightening the sway bar end links as successful. Are there any others out there with cause/cure successes ?
 
D

donnyonee

New Member
Jul 26, 2005
64
0
0
Nov 26, 2005
#2
  • Nov 26, 2005
  • #2
ttt
 

karazuba

New Member
Dec 17, 2004
26
0
0
Bay Area, CA
Nov 26, 2005
#3
  • Nov 26, 2005
  • #3
my success? took it to the dealer and made them fix it under the TSB. Perfectly fine since
 

hottymustang

New Member
Oct 10, 2005
58
0
0
Temecula, CA.
Nov 27, 2005
#4
  • Nov 27, 2005
  • #4
Same here, I took it to the dealer and had it done under the TSB. No more problems for me!
 

PonyboyIsaac

New Member
Aug 20, 2004
79
1
0
Nov 27, 2005
#5
  • Nov 27, 2005
  • #5
My sister 05 GT had some clunks coming from her front suspension, took it to the dealer and they replaced the front struts, noise has never come back.
 

bat24

New Member
Dec 28, 2004
66
0
0
YUMA,AZ
Nov 27, 2005
#6
  • Nov 27, 2005
  • #6
can sombody tell me witch tsb this is
 
T

thump_rrr

New Member
Nov 25, 2004
220
0
0
Montreal, Canada
Nov 27, 2005
#7
  • Nov 27, 2005
  • #7
TSB 5-9-11 Front End Popping Noise

FORD: 2005 Mustang

ISSUE:
Some 2005 Mustang vehicles built before 4/8/2005 may exhibit an intermittent popping noise from the front of the vehicle while turning left or right. The noise will typically occur during low speed maneuvers and may occur multiple times while turning.

ACTION:
On both sides of the vehicle, install a revised upper strut bearing assembly. If the vehicle was built before February, 2005 it may also be necessary to install a lower spring seat isolator if one is not already present. Refer to the following Service Procedure.

SERVICE PROCEDURE

Remove the strut and spring assembly. Refer to Workshop Manual Section 204-01.
Disassemble the strut and spring assembly.
If the springs do not have a rubber isolator on the bottom spring coil, install isolators. Clean off any dirt prior to installing the isolator. The isolator should be installed 4" (100 mm) from the end of the coil (Figure 1).

Reassemble the strut and spring. During reassembly, make sure the lower spring coil is butted up against the lower spring seat on the strut and the upper spring coil is butted up against the upper bearing assembly.
NOTE: INSTALL ALL NEW FASTENERS DURING REASSEMBLY.

NOTE: VEHICLE ALIGNMENT IS NOT REQUIRED AFTER THIS REPAIR.
 

bat24

New Member
Dec 28, 2004
66
0
0
YUMA,AZ
Nov 27, 2005
#8
  • Nov 27, 2005
  • #8
thanks
 
You must log in or register to reply here.

Similar threads

Suspension End link replacement size
  • Teen'93stang5.0
  • May 12, 2026
  • Fox 5.0 Mustang Tech
Replies
6
Views
156
Fox 5.0 Mustang Tech May 20, 2026
Teen'93stang5.0
S
65 Mustang: Tried to install a tachometer from Oreilly's with no success.
  • spearce
  • Mar 26, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
12
Views
678
1965 - 1973 Classic Mustangs -General/Talk- May 19, 2026
spearce
S
Progress Thread 91GTstroked 90 7 up convertible build
  • 91GTstroked
  • Apr 18, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
333
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 22, 2026
91GTstroked
Drivetrain Rear end clunk
  • seanmahoney
  • Oct 13, 2025
  • SN95 4.6L Mustang Tech
Replies
3
Views
422
SN95 4.6L Mustang Tech Oct 13, 2025
nickyb
H
Ongoing Battle With Hydraulic Lifters
  • hailer06
  • Jun 8, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
310
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 9, 2026
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 2005 - 2014 S-197 Mustang -General/Talk-
  • 2005 - 2009 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?