Svttech another one for you

[Cantslowdown]

Ok well me and a tec did the brake job sat on my car..We had to go get new brakets and slide pins for the back..I put on new pads and rotors..The piston was kinda hard to turn at frist but it went back in..But the slide pins where just gone rusted one is stuck we beat it on the floor and wouldnt move it came off the drivers side and i still have a sound form the back drivers side with all new parts..So could the caliper it self be bad?

 

[Mike97gt]

thius is a rubbing sound durring turns?

first thing I would look at is make sure the ebrake cable is secured and away from the wheel.. After that I would remove the rotors and check to make sure you don't have the abs tone wheel contacting something when the axles are moved in and out.

if none of that works try using the chasis ears and hang sensors all over the rear brake area, that will tell you exactly where the noise is located.

 

[Cantslowdown]

I see it coming form the same side its not near is loud tho..But still there..Its more like a squeking sound..

 

[Mike97gt]

is this sound over bumps or around corners

 

[Cantslowdown]

Both..The road coming down to my house is bummpy and it dose it not even on the brake..

 

[Mike97gt]

ok try putting the e brake on lightly and drive over bumps and turn. see if it makes the noise. Only do this for short periods of time.

 

[Cantslowdown]

Welp today pull into work get out smell something odd look down my rotor is blue and really hot so i guess sticking calper.So i have two new ones here tmw for the car.. Guess thats the problem.

 

[Mike97gt]

yep a brand new rotor turning blue would indicate a caliper issue

 

[Cantslowdown]

I just hope i can scuff the rotor and be alright.

 

[Mike97gt]

you should be fine.