Swapped 02 2v in my 89 coupe....need elec schematics

CarMichael Angelo · Jan 11, 2011

I dont need alot, I'm not running F/I or the eec for that matter, but I need a start/charge/run schematic for an 02' so that I can wire the starter and alternator properly. I have a chilton manual for the year in question and the schematic there is too vague (lists it as"typical" for a 4.6 in a mustang)

I need a specific diagram that shows where the wires go on the starter, & The alternator (i had to buy a pigtail to splice the alternator in with) and where they tie back to since I have eliminated the EEC.

CarMichael Angelo · Jan 12, 2011

no takers?....after 40 views.
Should've left the 4 cyl in it. At least those guys step up and help when asked.

2002BLGT · Jan 12, 2011

madmike1157 said:
no takers?....after 40 views.
Should've left the 4 cyl in it. At least those guys step up and help when asked.

Smart remarks will get you even less help , go to alldata.com and pay for a subscription and print wiring diagrams all you want

wmburns · Jan 12, 2011

I'm not sure that I understand what you want. This board gives limited space to post diagrams. The later MY Mustangs don't have a simple design. The complete start/charge/run diagrams would be 10-15 diagrams. Remember that the Mustang uses several "always on" circuits in combination with control circuits. Also the power distribution goes through a "hybrid" system using the ignition switch and CCRM.

If your question were more focused, I could help. But posting the entire Starting and charging diagrams is beyond what can be done with the space allowed.

Good luck.

CarMichael Angelo · Jan 12, 2011

2002BLGT said:
Smart remarks will get you even less help , go to alldata.com and pay for a subscription and print wiring diagrams all you want

Gee Thanks for the advice, I would've never thought of paying for help. Maybe you should offer that advice to every other poor sap looking for something for free on this board.

CarMichael Angelo · Jan 12, 2011

wmburns said:
I'm not sure that I understand what you want. This board gives limited space to post diagrams. The later MY Mustangs don't have a simple design. The complete start/charge/run diagrams would be 10-15 diagrams. Remember that the Mustang uses several "always on" circuits in combination with control circuits. Also the power distribution goes through a "hybrid" system using the ignition switch and CCRM.

If your question were more focused, I could help. But posting the entire Starting and charging diagrams is beyond what can be done with the space allowed.

Good luck.

Ok, specifically, I need to know where the three wires from the pig tail on the stock alternator go to, (The big wire is self explanatory)and where the small additional wire on the starter originates from.
Thanks, This was all I was asking for.

Swapped 02 2v in my 89 coupe....need elec schematics

CarMichael Angelo

my rearend will smell so minty fresh,

CarMichael Angelo

my rearend will smell so minty fresh,

2002BLGT

Well-Known Member

wmburns

CarMichael Angelo

my rearend will smell so minty fresh,

CarMichael Angelo

my rearend will smell so minty fresh,

Similar threads

Swapped 02 2v in my 89 coupe....need elec schematics

CarMichael Angelo

my rearend will smell so minty fresh,

CarMichael Angelo

my rearend will smell so minty fresh,

2002BLGT

Well-Known Member

wmburns

CarMichael Angelo

my rearend will smell so minty fresh,

CarMichael Angelo

my rearend will smell so minty fresh,

Similar threads

Privacy & Transparency

Privacy & Transparency