• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2.3L (N/A & Turbo) Tech

TC Stalls and Bucks after it warms up

  • Thread starter Thread starter Dustang83
  • Start date Start date Mar 29, 2006

Dustang83

New Member
Oct 30, 2001
15
0
0
Lorain, Ohio
Mar 29, 2006
#1
  • Mar 29, 2006
  • #1
Maybe someone has had this happen to them before..... It only happens after the car has been running for 5+ minutes or so and only under part throttle. It has no bearing on full throttle performance. When you are cruising down the road at say 2000 rpm, the car (1988 Turbo Coupe) will just cut out, or buck, like someone killed the ignition for a second. Then when you come to a stop, or push in the clutch, the idle becomes erratic, and it wants to stall. If you give it gas, you can keep it running, but if you let your foot up, it will eventually hover around and die. If you continue to drive it, sometimes it goes away, but most of the time it doesn't. I have my knock sensor unplugged. Other than that, I have a K&N cone air filter, and a HBC boost controller on it. I set the timing to 10 degrees (spout unplugged), replaced the plugs, Oxygen Sensor, and had the TFI module tested and it passed.
I'm getting two codes:
28-Vane air temperature (VAT) out of range
34- EGR on/off switching not detected

I put a vacuum gauge in place of the EGR valve and it gets 7" of vacuum during the self test. I read also that if the car was taken in for a recall, that this 34 code would remain in your computer no matter what happens. How can I test/repair the VAT? Any other suggestions would be greatly appreciated! Thanks
Dustin
 

Dustang83

New Member
Oct 30, 2001
15
0
0
Lorain, Ohio
Apr 12, 2006
#2
  • Apr 12, 2006
  • #2
Found out what it was..... something stupid.....
I guess I had put the vacuum check valve for the EGR valve on backwards, so it would let boost get to it, but not vacuum!
 

16vstang

New Member
Oct 8, 2004
100
0
0
Way up in Maine
Apr 13, 2006
#3
  • Apr 13, 2006
  • #3
Sounds like somthing I would do
 
You must log in or register to reply here.

Similar threads

S
Fuel ‘88 GT Runs Rich Cold — Fixes Itself When I Unplug Sensors (ECT, MAF, O2, etc.)
  • Sufarry
  • Nov 6, 2025
  • Fox 5.0 Mustang Tech
Replies
12
Views
858
Fox 5.0 Mustang Tech Nov 9, 2025
Mustang5L5
J
Emission problems
  • jls.zmmr
  • Feb 5, 2026
  • 1994 - 1995 Specific Tech
Replies
2
Views
247
1994 - 1995 Specific Tech Feb 7, 2026
AeroCoupe
S
Fox '87 GT can't get to stay running
  • spilly
  • Mar 29, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
27
Views
823
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 20, 2026
spilly
S
SURGING IDLE / NO IDLE CHECKLIST FOR 1996–1998 MUSTANG GT (4.6L 2V) - Work In Progress
  • Noobz347
  • Aug 30, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
740
1996 - 2004 SN95 Mustang -General/Talk- Aug 30, 2025
Noobz347
J
Thanks for the information on codes 31,34,44 and 94!
  • JK86LX50
  • Mar 5, 2025
  • The Welcome Wagon
Replies
3
Views
293
The Welcome Wagon Aug 5, 2025
gkomo
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2.3L (N/A & Turbo) Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?