That trickflow kit....

[95.0Stang]

450rwhp???

WOW, I DREAM of getting 300rwhp, that sounds like a very inexpensive way to get it...don't you think?

Probably need a new motor within 6-12 months though huh? Currently I have 82k miles on my car.

 

[95GTvert[bv12]]

with H/C/I you bottom end will hold up just fine for a long time just make sure it is balanced right because with this combo your going to be runing to 6200 instead of 5200, also i wouldn't worry about the buttom end untill you add boost to a combo like this.

 

[95.0Stang]

I am planning on Adding a Vortech A trim or S trim

 

[CivicEater]

I am putting my kit on in 2 weeks most likely, and for now all I have on is a Kirban AFPR, how long can I just have that cranked up to 60 psi before I break something? I only have like 115 bucks n the bank right now so I cant spring for injector's or fuel pump just yet. I was thinking I could get away with it till summer mabye?

 

[jeffbigwood27]

I just would like to say the kit is awsome but requires more parts than just what they give you. I put this kit on my car along with 30#injectors, 75 mass air, cold air intake, 70mm tb, 75 egr spacer, and converted to mass air. I must say this kit kicks some ace. The cam is sweet not to big and not to small. the only things that suck are no oil fill you have to buy that and you have to buy the timing cover and water pump gaskets. And the back bolt on the upper intake is a BITCHHHH.

 

[CivicEater]

you dont happen to have the part numbers for the timing and water pump gaskets do ya? I guess Ill order these from ford when I start

 

[jeffbigwood27]

Just go to autozone or the parts store near you and get a timing chain gasket set and get the waterpump to plate gasket and you are set. its like 20 bucks