I am swapping a Double Din head unit into my car (2002 GT), and keeping the rest of the Mach 460 sound setup. I went ahead and searched to find details on the swap, and came upon a lot of good info (primarily from this thread - LINK).
I just want to make sure I am ordering all the correct pieces I will need before I place my order. The unit I purchased does NOT have Low/High Pass Crossovers.
Parts list I have compiled....
1. Double Din Dash Kit (METRA 95-5026) - LINK
2. Wiring Harness (METRA 70-5519) - LINK
3. FMOD - (Low Pass - 50hz) - LINK
4. Bass Blockers - (High Pass - 150hz) - LINK
.
.
.
Questions I Have:
1. Am I missing anything, are there any parts I should change (such as FMOD/Bass Blocker frequencies)?
2. For the Bass Blockers I need 4 altogether correct? One set comes with two, so I should pickup two sets?
3. Where exactly do I wire in the bass blockers? In a post from the "Replacing Your Mach 460 Head Unit" thread, someone said - "You need 4. Put one on each of the + sides of the speaker" - how do I know which wires on the harness are the + sides of each speaker?
4. Last question. The headunit I purchased did not come with the mounting sleeve (one of the original parts it came bundled with - I bought it used). Pic of what I have talking about:
Do I need this part? Or does the dash kit just screw straight into the sides of the headunit?
Here is the sleeve mounted to the unit in another picture (I think the sleeve was not used in the install for the previous car it was in because it was not needed - thus why the seller no longer had it):
View attachment 265081
.
.
Unit Info:
- JVC KW-AVX710
- Bought it from a friend who had it in his Lincoln Aviator and swapped to something different. Picked it up in Mint Condition for only $100 bucks.
View attachment 265082
.
.
THANKS!
I just want to make sure I am ordering all the correct pieces I will need before I place my order. The unit I purchased does NOT have Low/High Pass Crossovers.
Parts list I have compiled....
1. Double Din Dash Kit (METRA 95-5026) - LINK
2. Wiring Harness (METRA 70-5519) - LINK
3. FMOD - (Low Pass - 50hz) - LINK
4. Bass Blockers - (High Pass - 150hz) - LINK
.
.
.
Questions I Have:
1. Am I missing anything, are there any parts I should change (such as FMOD/Bass Blocker frequencies)?
2. For the Bass Blockers I need 4 altogether correct? One set comes with two, so I should pickup two sets?
3. Where exactly do I wire in the bass blockers? In a post from the "Replacing Your Mach 460 Head Unit" thread, someone said - "You need 4. Put one on each of the + sides of the speaker" - how do I know which wires on the harness are the + sides of each speaker?
4. Last question. The headunit I purchased did not come with the mounting sleeve (one of the original parts it came bundled with - I bought it used). Pic of what I have talking about:
Do I need this part? Or does the dash kit just screw straight into the sides of the headunit?
Here is the sleeve mounted to the unit in another picture (I think the sleeve was not used in the install for the previous car it was in because it was not needed - thus why the seller no longer had it):
View attachment 265081
.
.
Unit Info:
- JVC KW-AVX710
- Bought it from a friend who had it in his Lincoln Aviator and swapped to something different. Picked it up in Mint Condition for only $100 bucks.
View attachment 265082
.
.
THANKS!