• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech

Time to change trans fluid on manual..

  • Thread starter Thread starter fanz
  • Start date Start date May 27, 2005
  • 1
  • 2
Next
1 of 2 Next Last
F

fanz

New Member
Aug 7, 2004
12
0
0
May 27, 2005
#1
  • May 27, 2005
  • #1
Well, I read the manual, and I got the DextronIII/Mercon bottles, but does anyone have a indepth guide to change the oil, preferably with pictures, I don't want to screw this car up? my car just hit 60K miles. I can remove the plug and let it drain but how do I know how much ATF to put it back in? Just see how much poured out and pray that I put in about the same amount?

I know for autos that theres a fluid check tube beside the engine, but sadly thats not the case with a manual. I also heard that some take off the shifter knob and pour it down there.. but again how much? Any other ways?

Oh, and I did search for transmission fluid, and tranny fluid, but to no avail of a good match..Sorry!
 

Give Me TP

Member
Jun 17, 2004
936
0
16
Republic of Texas
May 27, 2005
#2
  • May 27, 2005
  • #2
What year car and who made the transmission?
 
F

fanz

New Member
Aug 7, 2004
12
0
0
May 27, 2005
#3
  • May 27, 2005
  • #3
2000 5spd V6 Stang , T5 transmission
 
T

Tru_Blue_104

New Member
Nov 13, 2003
218
0
0
MN
May 27, 2005
#4
  • May 27, 2005
  • #4
I dont have an answer about how to change it. But if you have the manual, it should be a breeze. One suggestion though...use Royal Purple Sychromesh fluid in there. I heard its the best and will really smooth out the tranny. I'll be doing it sometime in the next few weeks.
 
F

fanz

New Member
Aug 7, 2004
12
0
0
May 27, 2005
#5
  • May 27, 2005
  • #5
i've actually heard some mixed comments on Syncromesh, some said that it was excellent to use, while others claimed that it could eventually wear down the transmission. I don't know who to believe, but I think the best choice, to be safe, is to stick with the manual and go Mercon, possibly Motorcraft brand if i can find it..
 

atreyu

New Member
Nov 13, 2003
44
0
0
Lewisville, tx
May 27, 2005
#6
  • May 27, 2005
  • #6
just pull the fill plug then the drain plug, drain it . put the drain plug back in. now for the hard part. well its not hard, just slow. get a funnel and some kind of a hose. put the hose in the fill plug and the funnel in the other end of the hose and pour the fluid into the funnel in tell fluid starts to come out the fill plug hole, the fuild level should be even with the bottom of the hole or slighly under it. p.s. make sure the funnel is higher than the fill hole.
 

Lsredy2kstang

Look, I'm special, dammit
Nov 29, 1999
2,543
5
0
Woodstcock, Georgia
May 28, 2005
#7
  • May 28, 2005
  • #7
Okay I just got done doing this! These are my impressions of this and only that. Do anything you want at your own!

First off you need a minimum of 2.7 quarts to do the job.

Second, you need a pump to pump the fluid into the tranny.

Third lots of towels if you do step two!

Third, it is a regular 3/8 drive ratchet to get the drain plug out as well as the fill plug.

Draining was easy as pie.

Filling it was a pain in the ass! You fill it just until it starts to come back out. That is a pain.

Next time, I will do it easier with littler mess and lost product!

Take off the shifter and fill directly into the tranny that way! I would say about 2.5 quarts to account for the fluid that is still inside that did not drain.

I used Royal Purple Syncromesh and say that I can fill a difference when the car is warmed up. Alot of people in our Club has used it and love it as well.
 

'03 6-Speed

New Member
May 23, 2003
216
0
0
Panhandle O' Texas
May 28, 2005
#8
  • May 28, 2005
  • #8
is there no filter that will need to be changed out?
 

Lsredy2kstang

Look, I'm special, dammit
Nov 29, 1999
2,543
5
0
Woodstcock, Georgia
May 28, 2005
#9
  • May 28, 2005
  • #9
No filter on manual, only automatics
 
F

fanz

New Member
Aug 7, 2004
12
0
0
May 28, 2005
#10
  • May 28, 2005
  • #10
err, so do I have to have the pump or can I just add it through the shifter?


[QUOTE='03 6-Speed]is there no filter that will need to be changed out?[/QUOTE]

Zing! Another one of many peaks of driving a manual Stang!
 

Give Me TP

Member
Jun 17, 2004
936
0
16
Republic of Texas
May 28, 2005
#11
  • May 28, 2005
  • #11
Add it through the shifter if you're going to have it off for some reason. If you had a Tremec 3650 refilling with 3L (3.2 quarts) of Dexron III would be just right. Otherwise, I agree with atreyu about refilling to the bottom or just a little below the filler hole.
 
F

fanz

New Member
Aug 7, 2004
12
0
0
May 29, 2005
#12
  • May 29, 2005
  • #12
alright i'll try that, guess i better buy a chilton repair manual too sooner or later.

Well, after this mess is over with, I need at least a weekend to do some body work to the rear qtr panel.. argh what a pain. Is the factory paint 3 coats or 4? I'm thinking 3... primer, color, clear coat. Meh whatever, plenty of time for that later.

edit - did you change anything? ehh, it's supposed to be "perks" if i mistyped.
 

Lsredy2kstang

Look, I'm special, dammit
Nov 29, 1999
2,543
5
0
Woodstcock, Georgia
May 29, 2005
#13
  • May 29, 2005
  • #13
Well actually, different color cars are different in layers of paint.

Mine, Laser Red has a base, tint and clear coat.
 
F

fanz

New Member
Aug 7, 2004
12
0
0
May 29, 2005
#14
  • May 29, 2005
  • #14
Well, done draining: didn't start until about 9PM, drained it. Watched the last part of the CC600 race, took off the first few layers of the shifter - too much trouble, so I went to get a tube. There were a few spider webs in it so I washed it out, and let it dry overnight.

Now I'm going to pray that I took off the correct Drain/Fill plug .

It's on the passenger side of the transmission about half way from the shifter and the engine right? The fill is the top one and drain's the bottom.

Well, as for fluid, I'll stick with DextronIII/Mercon. It's what was originally in there, and it's factory recommended. Sadly it's just SuperTech brand from WalMart - it was all they had, and it's cheap. While it probably won't be as great as brand names like Mobil or Vavoline, etc; I think it should do okay. I doubt that I'll be keeping this car for too long. I might sell off this car for $6500 in a month and spend a bit more to buy a GT.

Thanks for the advice/tips.
 

Lsredy2kstang

Look, I'm special, dammit
Nov 29, 1999
2,543
5
0
Woodstcock, Georgia
May 30, 2005
#15
  • May 30, 2005
  • #15
Once you got that first few layers off there are only 4 bolts that hold the shifter on!

When you are done let us know if it was really worth it or not!

Travis
 

Give Me TP

Member
Jun 17, 2004
936
0
16
Republic of Texas
May 30, 2005
#16
  • May 30, 2005
  • #16
fanz said:
Well, as for fluid, I'll stick with DextronIII/Mercon. It's what was originally in there, and it's factory recommended. Sadly it's just SuperTech brand from WalMart - it was all they had, and it's cheap. While it probably won't be as great as brand names like Mobil or Vavoline, etc; I think it should do okay. I doubt that I'll be keeping this car for too long. I might sell off this car for $6500 in a month and spend a bit more to buy a GT.

Thanks for the advice/tips.
Click to expand...

I am using Texaco (Havoline) Dexron III with good results. It's probably not much different than the WalMart SuperTech brand and I plan on keeping this car for a long, long time
 
F

fanz

New Member
Aug 7, 2004
12
0
0
May 30, 2005
#17
  • May 30, 2005
  • #17
well, was it worth it? Probably not, the car didn't feel any different - that's probably a good thing though. It probably done more for me than the car, just to know that it was changed.

I used the tube, cause everything was already prepared, and cause I was paranoid about dirt getting in the transmission through the shifter.

As for SuperTech, it's cheap but I think it should be the same thing as the factory fluid - sort of like namebrand and generic drugs. Most of the time, Supertech uses the same source as other namebrands, and often it's just a rebadged product from what I've heard.



Give Me TP said:
I am using Texaco (Havoline) Dexron III with good results. It's probably not much different than the WalMart SuperTech brand and I plan on keeping this car for a long, long time
Click to expand...
If I had that car, I would keep it for a long time too! Sadly, V8 coupe + college student doesn't bode well for insurance (ouch). Come to think of it, I might just try to sell this car and get a classic mustang or a project car instead of a GT - FD RX7, anyone?
 

mustangmat99

New Member
Jan 30, 2004
167
0
0
Jun 1, 2005
#18
  • Jun 1, 2005
  • #18
im fixing to change my trans oil myself...taking off the shifter, when you take off the boot and bezel and all that, the four bolts right there, is that the 4 bolts ur talking about? or are there more underneath that, i too have a 2000 mustang, with i assume a t5? whatever came stock in um, let me know thanx
 

Give Me TP

Member
Jun 17, 2004
936
0
16
Republic of Texas
Jun 1, 2005
#19
  • Jun 1, 2005
  • #19
mustangmat99 said:
im fixing to change my trans oil myself...taking off the shifter, when you take off the boot and bezel and all that, the four bolts right there, is that the 4 bolts ur talking about? or are there more underneath that, i too have a 2000 mustang, with i assume a t5? whatever came stock in um, let me know thanx
Click to expand...

Those are them. That would also be a good time to change shifters to the Tri-Ax?? you have in your sig.
 

Lsredy2kstang

Look, I'm special, dammit
Nov 29, 1999
2,543
5
0
Woodstcock, Georgia
Jun 1, 2005
#20
  • Jun 1, 2005
  • #20
What he has stated is true!
 
  • 1
  • 2
Next
1 of 2 Next Last
You must log in or register to reply here.

Similar threads

Drivetrain 83’ Glx convertible C5 Trans help!
  • JacksonJared2113
  • Dec 25, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
384
Fox 5.0 Mustang Tech Dec 26, 2025
JacksonJared2113
K
TKX Transmission Shifting Problem
  • KWC156
  • Jun 23, 2025
  • Other Auto Tech
  • 2
Replies
21
Views
2K
Other Auto Tech Jun 13, 2026
427nostang
4
M
Progress Thread mnky99 2001 V6 evap core, ac compressor, heater core replacement
  • mnky99
  • Sep 5, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
496
1996 - 2004 SN95 Mustang -General/Talk- Sep 5, 2025
mnky99
M
M
Fox Foxbody rear jack points
  • mcalvo
  • Oct 20, 2023
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
25
Views
7K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 12, 2024
limp
J
1995 Mustang V6 - Cyl #3 Misfire - Help!
  • JasonBlue
  • Aug 30, 2023
  • 1994 - 1995 Specific Tech
  • 2
Replies
34
Views
5K
1994 - 1995 Specific Tech Oct 20, 2023
def_68
D
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?