timing issue

simaj14

New Member
Jul 18, 2007
3
0
0
hey guys, i just bought a 90 gt, 5.0 5spd, w gt40 heads, f303 cam, trick flow street heat intake, 70mm throttle body, full exhaust, t5 world class trans, 3.55's. the timing is off, and i dont have a clue as to what it should be set at with these mods. please fill me in. thanks
 
It's a trail and error type thing to find the sweet spot for any combo. Just keep bumping it a couple of degrees at a time until it slows down or starts to spark knock. My guess is probably some were between 10-18 degrees with the spout removed.
 
Make sure you run 93 octane. The stock setup is 10 degreese advance running 87 octane. I would run 93 and start at 14 then to 16 and so on past 18 I would say is to much.
 
Many things can play into what the balancer reads for timing that have nothing to do with what is happening in the cylinder. For example after degreeing my cam I found that my timing mark/balancer combo was 2 degress off when the engine was actual at top dead center. I have also ran gt40 headed engines with 16 degrees of timing on 87 octane. So tune with what ever fuel you intend to run. If you want to pay more for 93 all the time then tuning for 93 is fine. However if you tune for 93 and then run 87 you could run into problems.

Keep in mind the octane rating is not a power making rating. The higher the number the slower the burn rate which helps avoid detonation. Take a car tuned for 87 and put some 114 in it and watch it slow down. It's basicly like retarding the timing.