• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

TPS help

  • Thread starter Thread starter lcaptmorg
  • Start date Start date Jul 24, 2008
L

lcaptmorg

New Member
Jun 3, 2007
5
0
0
Jul 24, 2008
#1
  • Jul 24, 2008
  • #1
5v in all three tps wires. Hmm that can't be right. Short perhaps. Any one seen this before. Suggestions. God I hate tearing the wiring harness down.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jul 24, 2008
#2
  • Jul 24, 2008
  • #2
Unplug the TPS sensor and check the body-harness wires (key on). Now you should be back to one wire showing 12 volts. Ohm out the ground wire, looking for low single digit resistance). You can check continuity between the 3 wires to be sure there is none.

Then do continuity tests between the 3 terminals on the old TPS. They probably have low resistance (continuity).

If that all hashes out, a new TPS should have you back to normal.
 
L

lcaptmorg

New Member
Jun 3, 2007
5
0
0
Jul 24, 2008
#3
  • Jul 24, 2008
  • #3
You guys are gonna love this one. From the engine harnes Orange wire 5v black wire has 5v also 0 on green.

TPS continuity
G/B .5
G/O 3.5
B/O3.8

Looks like the tps is good plus I swaped it with a spare I had. Testeed both of them and results were similar.

Pulled the black out from the tps and ran to a local ground. Tps dead on 5v in and .99 out.

More suggestions.

Thanks

Sorry some additional info restance on black wire into the harnes 4.3. SHORT!
 

joel5.0

Member
Jun 15, 2004
429
2
18
Puerto Rico
Jul 24, 2008
#4
  • Jul 24, 2008
  • #4
I know you're concentrated on the TPS but, have you run a KOEO self test?..... any other failure codes showing? ... BP, ECT, EVP, ACT ?..... can you initiate a self test by installing a jumper between the STI and SIGRTN terminals in the VIP connector?...... LUK
 
L

lcaptmorg

New Member
Jun 3, 2007
5
0
0
Jul 24, 2008
#5
  • Jul 24, 2008
  • #5
I am getting codes 51 22 53 31 67 81 82 84 85. No emmision equipment on this car. No egr smog pump, canister etc.

I have been sorting throught these but could figure out how they were realated.

This started with hot start problem. Would turn over great run forever but when I shut it down no restart. Tested fuel pressure and spark at the coil and plug. All tested well. Plugs were wet which got me thinking about flooding. Tried the old peddal to the floor with no luck. Then got me thinking ECT and tps at wot not shutting off injectors.


Worth noting that when i grounded the tps localy and set the tps to .99. Car runs I let it warm up and tried a restart. Cranked on it for a minute with out starting then pedal to the floor it fired right up. I think that was the problem with the hot start but now why the tps voltage problem.


I noticed the bap, tps, ect and act use a common ground wire. Is this the case? If so could it simply be a grounding problem. That would make me happy. Im thinking it might explain the codes for the other items as well.


Well what do you know, the neutral safety swich grounds on that circuit as well code 67. HMM Im starting to think grounding problem

Ok moving on. 5v coming out of sig ret wire through salt shaker from main harness. Now I know thats not right. Shouldn't that be 0v ... guess i will just keep going.


Well 5v comming out of pin 46 on ecu. Anyone car to venture a guess. At this point Im stumped. Thought for sure I would find something by now. Any help is really appreciated.
 
L

lcaptmorg

New Member
Jun 3, 2007
5
0
0
Jul 24, 2008
#6
  • Jul 24, 2008
  • #6
No guesses. This is as far as my knowledge takes me.
 
L

lcaptmorg

New Member
Jun 3, 2007
5
0
0
Jul 24, 2008
#7
  • Jul 24, 2008
  • #7
Got it. Bad connection at the ecu pin 46 and the harness. Thanks for all the info and info in past threads guys.
 
You must log in or register to reply here.

Similar threads

A
Electrical electric mirror switch issue...
  • alchemist1
  • Apr 18, 2026
  • Fox 5.0 Mustang Tech
Replies
1
Views
189
Fox 5.0 Mustang Tech Apr 19, 2026
2000xp8
S
Electrical Stumped No Start...
  • sydhawk
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
8
Views
385
Fox 5.0 Mustang Tech Oct 29, 2025
sydhawk
S
G
Resolved Smoking Wiring Issue After GT40 Head Swap
  • Grapes
  • Aug 15, 2026
  • Fox 5.0 Mustang Tech
Replies
17
Views
587
Fox 5.0 Mustang Tech Aug 22, 2026
Grapes
G
S
Resolved 83 alternator wiring harness
  • sparten5000
  • Aug 2, 2026
  • Fox 5.0 Mustang Tech
Replies
2
Views
190
Fox 5.0 Mustang Tech Aug 23, 2026
limp
Electrical Ron Francis Headlight / Alternator Harness
  • dan50
  • Apr 30, 2026
  • Fox 5.0 Mustang Tech
Replies
0
Views
331
Fox 5.0 Mustang Tech Apr 30, 2026
dan50
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?