TPS question

theconductor

15 Year Member
Aug 9, 2007
337
96
74
Roseville, CA
I was bored today so I thought I would check my tps voltage in response to some codes. I kept getting 4.xx volts no matter what I did. I have done this before with no problems. Any ideas why the reading would be so high?

Thanks,

-kyle
 
If the signal was reading 4.XX volts, disconnect the TPS electrical connector and check continuity between the signal and VREF wires (on the TPS itself).

While the TPS is disconnected, check voltage in the signal wire (in the car's harness). It should be zero. If you find voltage in the wire, it might be shorted to VREF down the harness.

Good luck.