Tranny Question

Georgie

New Member
Jul 13, 2005
455
0
0
Montreal, Canada
I finished my AOD to T5 swap a while ago, and everything seems to be well... but when i think back, i recall removing a inspection plate on the AOD. Is their supposed to be one on the T5??? cuz now i can clearly see the flywheel. I'm scared something might get in their....

What can i do??:SNSign:
 
... img5522vs9.webp
 

Attachments

  • img5522vs9.webp
    img5522vs9.webp
    2.8 KB · Views: 110
Yeah man, I don't know about that plate. I wouldn't want my flywheel exposed like that. You might end up getting debris in your clutch. Your spacer plate should look like this one from 50Resto:

lrs-7007b.jpg


Notice that it is one piece and there is no inspection plate. I looked up your part on summit and this is what it says in the description (I highlighted the important part in bold):

One plate for all of your mounting solutions.
These Performance Automatic multi-fit block plates are designed for all Ford small block engines. They are made from 0.060 in. thick steel and are gold iridited for durability. They work with automatic transmissions and fit both the 157-tooth and 164-tooth flexplates. The plates also feature special ventilation holes for better air circulation.

If you look at the "Check to make sure this part fits your application" link, it will only confirm that that is an automatic only spacer plate. Sorry man, but it looks like you ordered the wrong part.
 
That picture is where I got your part number from and yes, I did see that it said the plate was for manual tranny's as well. I was going off of what summit racing's website had to say about it because I'd much sooner trust them with information.

I'd call Performance Automatic. It looks like ****ty product for either transmission if there isn't supposed to be something there. How many cars have you seen that drive around with their flywheels and clutches exposed to the elements like that? It doesn't make sense that they don't provide an inspection plate unless you are supposed to reuse your old one or replace it with new stock. That is the only solution I can think of unless you feel like tearing everything off again and replacing it with the correct spacer plate.

Just imagine the clutch slippage if you ever had to drive this car in the rain...
...or if something were to fly up in there and bust teeth off of your flywheel.