trans assembly Q

[Black70Fastback]

the slider part of the 3rd/4th synchro assembly has more of a bevel on one side than the other in my t5. i forgot which side faces the front of the transmission. please help. im very close to putting the thing together

 

[mytight95]

the bevil goes to the imput shaft end of the case, i have a rebuild manual in adobe format i could send you if you want to just check things out.

my e-mail is [email protected]

 

[Black70Fastback]

thanks, thats what i did. its all together now except the tail shaft housing. i didnt get the speed gears yet. i already had a manual downloaded from tremec but the picture was crappy and it didnt say how to put it on other than "the same way it came off."

 

[mytight95]

cool man, are you changing the drive gear on the output shaft for gears or something, if you don't have a stock gear i could send you one instead of buying one. But you can get whatever you need at a local tranny parts store, they will probably have what you need in stock

 

[Black70Fastback]

we're putting 3.73s in it almost immediately after the trans gets put in. i drove all over saterday and most places said they could order it. others said they wont even bother. how much does the drive gear usually cost? the last time i bought a driven, i think it was like ten bucks.

 

[mytight95]

the drive gears are like 10$, have you went to the hanlon motorsports speedo calculation page yet it will tell you what drive and driven gears to get. I changed my drive gear to a black 10 tooth gear and my driven was a 19 tooth gear which is what i needed so i left it alone


jason