trouble pulling codes, help?

Randy Kemper

Founding Member
Apr 22, 2000
102
0
0
I've got the connectors jumped and I'm running a test light from the battery to the other pin on the connector. When I turn on the key after a few seconds the light comes on and stays on. no blicks or anything. I'm sure I've connected everything right. Is there something I'm overlooking? Or is this a sign of something serious wrong with my computer. My cars not running right, right now, it's dumping gas, getting about 2 miles a gal. and won't stay running below 3k. Any help would be appreciated. Thanks
 
Just in case you missed something in hooking things up...

Here's the link to dump the computer codes with only a jumper wire or paper clip and the check engine light, or test light or voltmeter. I’ve used it for years, and it works great.

See http://www.troublecodes.net/Ford/
OR
See http://www.mustangworks.com/articles/electronics/eec-iv_codes.html

IF your car is an 86-88 stang, you'll have to use the test lamp or voltmeter method. There is no functional check engine light on the 86-88's except possibly the Cali Mass Air cars.

Codes have different answers if the engine is running from the answers that it has when the engine isn't running. It helps a lot to know if you had the engine running when you ran the test.

Trouble codes are either 2 digit or 3 digit, there are no cars that use both 2 digit codes and 3 digit codes.

For those who are intimidated by all the wires & connections, see http://www.actron.com/product_detail.php?pid=16153 for what a typical hand scanner looks like. Normal retail price is about $30 or so at AutoZone or Walmart.

Or for a nicer scanner see http://www.midwayautosupply.com/detailedproductdescription.asp?3829 – It has a 3 digit LCD display so that you don’t have to count flashes or beeps.. Cost is $35.
 
jrichker, I actually double checked my connections using one of your links before I posed the question. Thanks. I've got an 86 gt, was running a koeo test, or trying to. I was using the test light. I've always used the voltmeter method before and never had any problems. But I seem to have misplaced it.
 
If you get a code 67 while running key on engine off tests, the key on, engine on test will not run.

Code 67 - clutch not depressed (5 speed) or car not in neutral or park (auto) or A/C in On position when codes where dumped. Possible neutral safety switch or wiring problem. This code may prevent you from running the Key On Engine On tests. You can generally ignore this code, since it has no effect on engine performance.
 
I too, am having this problem. Listening in!

The voltimeter swings wide open, all the time... constant 12v power. (i think it was 12v.. i don't remember.. but it was voltage)
 
You would have to do a check of the 5vdc VREF supply at the TPS connector, TPS disconnected, first. You would, unfortunately, have to get your misplaced voltmeter or,....could you borrow one from a friend? LUK