Turbo with ported heads

94Blue302GT · Oct 23, 2004

Do you think it will be well worth the investment to put new heads on a turbo stang? I am getting a 60-1 which should be enough to split the block(properly tuned) and i'll be building a custom upper intake, exhaust, etc. but i don't think it should be necessary to replace the heads that i previously ported and polished (never got to run with them). Do you think i should just up the boost, or try to get some better heads to make better use of the same boost?

95snoozer · Oct 23, 2004

i woudl definitely do some exhaust work.

the e7 is a POS on the exhaust.

Killercanary · Oct 23, 2004

I agree, if you keep the E7's definitely work over the exhaust ports.

I'm SLOWLY building my own turbo car out of a 90GT. Its going to be a single turbo'd STOCK LONG BLOCK with a C4 which I already have. The reason is that it should run mid to low 11's and make 400rwhp+ when I'm done. I don't want the expense of an aftermarket head and I don't want enough power to split the block. I decided to go this route instead of turbo'n my '95 because I knew even with mild boost levels I'd be into block splitting territory.

madams74 · Oct 23, 2004

I would not go over to much on the exhaust ports. You want to keep your low end for that tire burning torque.

95snoozer · Oct 23, 2004

tell me you are joking

HE IS GOING TURBO!

Turbo with ported heads

94Blue302GT

Member

95snoozer

Active Member

Killercanary

The car that set the bar.

madams74

95snoozer

Active Member

Similar threads

Turbo with ported heads

94Blue302GT

Member

95snoozer

Active Member

Killercanary

The car that set the bar.

madams74

95snoozer

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency