Twin Turbo Notch

whtnotch

New Member
Jan 8, 2007
123
0
0
Chicago
I have a 89 Notch. I'v read a bit about turbos on here and people are saying not to go with an e-bay twin turbo.why?I don't see anything wrong with it. A dude I met up with on Archer ave has a single setup he purchased off e-bay,and his car is fu*in tits. Also how would I hook exhaust up off turbos without welding to H-pipe.Is there a kit?or all has to be fabed up?injector size?fuel pump size?anything else to watch out for.

thanks alot
 
Thats exactly why you dont buy ebay turbo kits. any reputable company would work with you on setting up your turbo kit.

take a look over on www.turbomustangs.com they will more than likely be able to help you better understand "why" better than us.

but the main reason not to buy an ebay turbo setup is because its crap. the turbos are more than likely used/ cleaned up turbos which will fail. the intercoolers re ot efficiant and the hot side parts are not made of acceptable materials and the welds are doomed to fail
 
Man this is budget build. They can't be total "crap"I seen one used and it was runnin smoothly and next to my car it riped it up with his being bone stock plus "e-bay turbo" and upped injectors,I know about the site they want 2k+ for their turbo setups I might as well buy a charger for that price.Anyone buy e-bay turbo setup.I'm not talkin bout the intercooler welds.i'll most lilkley blow bottom end before blowin up the turbos.
 
Man this is budget build. They can't be total "crap"I seen one used and it was runnin smoothly and next to my car it riped it up with his being bone stock plus "e-bay turbo" and upped injectors,I know about the site they want 2k+ for their turbo setups I might as well buy a charger for that price.Anyone buy e-bay turbo setup.I'm not talkin bout the intercooler welds.i'll most lilkley blow bottom end before blowin up the turbos.

If you want to do a budget build, your going to have to do some major fabrication yourself…there is no way around it. The cheap e-bay kit's typically use thin walled steel for their headers which will burn through in short order…and their quality is suspect at best. They typically do not fit very well at all…especially the full kit's. From what I've seen, many will require you to re-route their setups as they were not setup on a jig properly. They also seem to include undersized intercoolers which

You need to keep in mind that the quality control on a turbo is ABSOLUTELY CRITICAL. Blowing one up is not a matter of pushing it to hard…but rather running it on a day to day basis. These things commonly spin well in excess of 100k rpm…and any flaws in the oiling system, compressor/turbine balance and housing imperfections can cause a catastrophic failure.

If you are complaining about the costs….I dare you to find an intercooled supercharger setup that includes headers for anywhere near $3k (B&G and Quicktime have kit's for under). Let's not forget either that the cheaper superchargers are not capable of supporting anywhere near the levels that the lower end B&G kit's can.

If you want cheap…I suggest you fabricate everything yourself. Take your stock headers and flip them upside down and go to town and invest in a set of turbocoupe .60/.63 or .60/.48 turbos. There are plenty of builds on turbomustangs.com which do just that….and it can be done on an extreme budget. Hell, my initial build cost around $2k and including B&G headers, a Pro-M univer MAF and 42lb injectors.