Twisted Wedge Heads

ga94gt

New Member
May 17, 2007
138
0
0
Ringgold GA
I am looking into a Twisted Wedge top end kit and it comes with the non-oringed heads. Is there going to be a difference between the non-oringed and the oringed heads. Would the oringed heads be better?

Any info would be great.

Thanks Garrett
 
Personally, I do not see the need for O-ringed gaskets anymore. If the tune is going to be good and you KNOW it's going to be good then run regular head surfaces and a set of cometic gaskets.

Your internal parts will give before the cometics do. They also require a little more prep of the mating surfaces than regular head gaskets.
 
O-ringed heads have a groove that is cut around each chamber in the surface of the head that meets the block. Then special o-ringed head gaskets are used to fit into the groove, that when bolted down, create a seal around each cylinder to allow for more cylinder pressure. Be sure to use a set of quality gaskets, for they are vital in creating a strong seal between the heads and the block.

As alluded too, unless you are looking to make big power or lots of boost, a regular design cosmetic headgasket will work fine. Use ARP head studs.

Here are the headgaskets recommended by Trickflow:

Fel-Pro 8548PT-2 for mild engines with non O-ringed heads.

Fel-Pro 1011-2 for higher performance engines with non O-ringed heads.

Fel-Pro 1022 and 1023 for non O-ringed heads with wider combustion chambers due to porting (1022 is for the left bank, 1023 is for the right bank).

Fel-Pro 1006 or TFS-51400901 for all engines with O-ringed heads.

Street Heat/Twisted Wedge Heads:

TFS-51400003 – TW/Street, 170cc Head, 61cc, 1.470" Single Valve Spring (.540”), 7* locks, 3/8” rocker studs, smog provisions and machined for o-rings. $1,310.

TFS-51400005 – TW/Street, 170cc Head, 61cc, 1.460" Dual Valve Spring (.600”), 7* locks, 3/8” rocker studs, smog provisions, and machined for o-rings. $1,340.

Track Heat Heads:

TFS-51400011 – Track Heat, 170cc Head, 61cc, 1.460" Dual Valve Springs (.600”), 10* locks, 7/16” rocker studs, no smog provisions, and machined for o-rings. $1,380.