Hi, All--
Would anyone happen to know the dimension between the U-joint centerline of the pinion yoke to the centerline of the axle on an 8-inch rearend?
I'm trying to figure out the best way to go with my 8.8; I can either use the standard flat flange that comes on most of these axles and buy an adapter to mate to the flange, or I can get a standard pinion yoke from something like an F-150 and use that.
However, the dimension figure for the 8-inch will probably dictate which way I go, so I need to try and determine this . . . anybody know what that figure is?
Thanks in advance!
Would anyone happen to know the dimension between the U-joint centerline of the pinion yoke to the centerline of the axle on an 8-inch rearend?
I'm trying to figure out the best way to go with my 8.8; I can either use the standard flat flange that comes on most of these axles and buy an adapter to mate to the flange, or I can get a standard pinion yoke from something like an F-150 and use that.
However, the dimension figure for the 8-inch will probably dictate which way I go, so I need to try and determine this . . . anybody know what that figure is?
Thanks in advance!