upper control arms????

srothfuss said:
The FRPP unit doesn't do anything from what I have read on the forums...

Sure they do...they keep the rear end from binding by using slightly more rigid rubber bushings than stock.

Maximum motorsports has a good write up on their webiste about rear suspension bind using poly busings.
 
The FMS uppers are a waste of money, i got them years ago, they are just a glorified stock replacement, not worth the trouble of the install. Same with the cheap set of steeda, that look like stock.

Double adjustable uppers are the way to go. Steeda has a set that have a poly bushing on the car side, which are good for a DD. Also comes with a new bushing set for the rear side of the car.

I happened to have a set without that bushing, a heim joint in it's place, but my car see's few miles a year it seems.
 
2000xp8 said:
The FMS uppers are a waste of money, i got them years ago, they are just a glorified stock replacement, not worth the trouble of the install. Same with the cheap set of steeda, that look like stock.

Double adjustable uppers are the way to go. Steeda has a set that have a poly bushing on the car side, which are good for a DD. Also comes with a new bushing set for the rear side of the car.

I happened to have a set without that bushing, a heim joint in it's place, but my car see's few miles a year it seems.

Then why would one of the leading aftermarket suspension companies (MM) recommend them?

If you plan on doing more than driving in a straight line...and plan on keeping the stock 4-link suspension setup then they are the logical number one choice.

Poly bushings in general are a bad choice for anything but dragracing...unless they are a multi-piece design that allows proper axle movement.

Here is a nice sight which explains some mustang suspension basics.

http://www.miracerros.com/mustang/t_suspension.htm#Rear
 
everyone that i have known with the fms uppers had bad wheelhop once they took the quadshocks off, when i put my edelbrock uppers and mm lowers(all solid bushings) the car hookes way better on the street and there is only wheelhop when the ground is cold
 
90lxcoupe said:
everyone that i have known with the fms uppers had bad wheelhop once they took the quadshocks off,

Were they still using the stock lowers? Did they change the upper bushings that are in the rearend housing? The only difference between the stock and the FMS uppers is the front facing bushing is twice as stiff as the stock bushing. Unless you do some other work (like the lowers and the rearend housing bushing) you won't notice much, if any difference. It's a package deal.