Upper plenum.....

[mustang70]

I was wondering how a ported upper plenum with a spacer compares to an aftermarket plenum. I know it sounds dumb, but I kinda like the pony on my upper plenum and don't want to give it up unless there's a big difference in power.

 

[codyGT]

Wow, Someone else like the OE Pony too.

I was wondering the same thing. I ported my upper and am using the Steeda spacer and a FRPP 70mm TB. I really couldn't tell a difference between this combo and the Accufab my friend put on his 99 GT.

I bought a C&L but I couldn't make myself replace the pony. Nor could I give Accufab free advertisment on my engine.

Modualar depot got 3hp out of p/p alone, and I know for a 100% on a dyno that a Steeda spacer adds 2-3hp.

 

[cryptic]

Plenum Porting,

Newbie to the site, I asked earlier about porting. Did you download schematics for the port job, or do it as you went?

 

[LI98GTStang]

For looks, other than the C&L one, I personally like the way they all look. My favorite though, is this one - not yet released.

edit. Sorry here is the link to the page...
http://www.brothersperformance.com/shop/mustang/bbk4.6plen96-00.html

 

[mustang70]

Cryptic: Check this out. I haven't done it myself yet. It doesn't look like it would be that hard. Especially since I have a compressor, die grinder, and assorted bits already.

Edit: It might help if I actually put the link up.
http://www.redpony.org/intakeporting.htm

 

[cryptic]

I dont think the link is working,

Cryptic: Check this out. I haven't done it myself yet. It doesn't look like it would be that hard. Especially since I have a compressor, die grinder, and assorted bits already.

Kicking there ass and stealing there gas.

 

[mustang70]

It should be there now.

 

[cryptic]

Plenum Porting,

Great link, thanks. Now I've got to make up my mind of either porting stock or waiting 4 the BBK.

 

[BVille99GT]

I like the BBk piece, wow nice

 

[spikeGT_99]

personally i love the polished accufab pieces, but i wish do i could keep the pony, from what ive seen a p&p job will get around the same #s as the c&l piece