UPR El-Glow gauges installed , pics here

Slow5.0

Active Member
Feb 13, 2003
2,554
0
46
Portland, OR
I got good deal on UPR Products El-Glow gauges and A/C faceplates
I did some modifications because i didn't liked hows bottom part (CEL,Air Bag ....) and part where turn signals/High beem is ,

Here is a few pics















 

Attachments

  • IMG_1151a.jpg
    64.9 KB · Views: 101
  • IMG_1153a.jpg
    76.9 KB · Views: 90
  • IMG_1157a.jpg
    81.7 KB · Views: 97
  • IMG_1156a.jpg
    84.9 KB · Views: 93
  • IMG_1198a.jpg
    58.3 KB · Views: 108
  • IMG_1199a.jpg
    34.1 KB · Views: 82
  • IMG_1200a.jpg
    52.7 KB · Views: 94
  • IMG_1170a.jpg
    27.9 KB · Views: 82
  • IMG_1171a.jpg
    26.9 KB · Views: 81
  • IMG_1172a.jpg
    26.3 KB · Views: 98
  • IMG_1173a.jpg
    28 KB · Views: 105
  • IMG_1174a.jpg
    25.5 KB · Views: 81
  • IMG_1175a.jpg
    28.4 KB · Views: 92
  • IMG_1176a.jpg
    17.9 KB · Views: 77
  • IMG_1205a.jpg
    38.8 KB · Views: 94
urban96 said:
i just recently did that to mine, cut out the dummy lights and stuff. i have the "reverse glow" ones tho
I wish I would have though about doing that on mine, I butchered my gauges up. But I m just gonn change the bulb colors.

how hard was it to change the A/C panet? You just have to tkae the radio/AC panel off right?
 
The Green GT said:
I wish I would have though about doing that on mine, I butchered my gauges up. But I m just gonn change the bulb colors.

how hard was it to change the A/C panet? You just have to tkae the radio/AC panel off right?

A/C panel was easy , just take radio console and A/C panel, take knobs off ,clean surface with alcohol and put that bad boy in there (its 3M tape)
 
heres what i did to mine

pic of the gauges before i cut it out



back



heres what i cutout. there was a little wire in there that i didnt want to chance cutting so i cut around it



installed. its too bright outside now to get a night shot tho

 
I have the same set of gauges, and just recently, they started dimming and cutting out on their own. I have checked the wires I had tapped into, and they are fine. Is there some way the little box connected to the gauges could have gone bad? And does anyone know what is inside the box? Say something inside did go bad, am I SOL??