Urethane Tonneau Cover (2 piece)

[DonRich90]

As anyone had any experience installing the 2 piece urethane tonneau cover on their convertible? I really like the "speedster" look. How hard are they to install?

Thanks, Don

 

[FivePointStang]

(SUBSCRIBED TO THIS THREAD)

 

[Saleen311]

im pretty sure you just sit it on top and hook it up with the seat belts

 

[upstech]

im pretty sure you just sit it on top and hook it up with the seat belts

That’s incorrect. There are two bolts that have to be installed on each side. There is a suction cup type thing at the points on each side of the Tonneau. In addition to that there is also a seat belt clip. I took it the ford dealer to have it done. I am not mechanically inclined. It cost like 150 I think.

IMO if I had to do it again, I’m not sure I would. It looks pretty badass when it is on but it is a pain to take on and off, especially by yourself. They are pretty large so storage may also be a concern. Hope I was somewhat helpful.

 

[mransr]

upstech, do you have a one piece or two piece cover?