Thanks was wondering how I was going to do so. Didn't know if I could swap the factory one over, plus the valve covers are actually TF so they should work.You should be able to drill it in the factory area and install the Trickflow oil filler. It even has the pcv port.
https://m.summitracing.com/parts/tf...8Gb8Zh36R9O4HdHEe7hSXLkEXLfBeFKgaAvAaEALw_wcB
Thanks how does it deal as far as the hole you drilled ? Does it come with a rubber seal or grommet?This is how I did it, some masking tape and a hole saw.
Gotcha, what size is that like a 1-2 inch hole saw?Well the the covers and oil fill came with grommet from Trick Flow, I looked online what hole saw size I needed and where it should actually go. For some damn reason I can't find the hole saw I used, I'll have to look in the shed tomorrow, Trick Flow makes some great stuff but the instructions are terrible with these kinda details.
Ha but I like to giveJust call Trick Flow and ask. That way none of us have to takefor giving you bad information.
Kurt
Gotcha, what size is that like a 1-2 inch hole saw?
Gotcha, what size is that like a 1-2 inch hole saw?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?