Vibration?

[scupking]

Ok so this is the DS that I'm going to get. http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=M4602J 1&comp=LRS

Also I will get this U-joint. How many u-Joints do I need?
http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=LW-23016 1&comp=LRS

 

[fobra559]

Is this the one to get?
http://store.summitracing.com/partd...400070+4294907673+4294840044+115&autoview=sku

Yeah, that's the one I got and you only need that and nothing else to do the install. Unless you race a lot a safety loop wouldn't be bad either.

 

[fobra559]

I have question, when you get DS for summitracing do you just take stock out and bolt aluminum ds ? Is that it or have to mod some stuff ? I am thinking to get one for my 02 mustang gt. Is the install easy or take it to shop to make sure proper alignment ?

No, it should bolt right on. Since you have a 5 speed it will bolt right in, but for auto's you would have to swap yokes. You should be fine. It's not that hard to install if your savy but if your not sure have a shop do it. It should only cost $50 bucks or so for the labor. Good Luck

 

[fobra559]

Ok so this is the DS that I'm going to get. http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=M4602J 1&comp=LRS

Also I will get this U-joint. How many u-Joints do I need?
http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=LW-23016 1&comp=LRS

Sounds good, It's the FRPP but really it's the same as the FMS one. Why do you need the U joints for? You should be fine with only the DS.

 

[scupking]

Sounds good, It's the FRPP but really it's the same as the FMS one. Why do you need the U joints for? You should be fine with only the DS.

The u-joints might be wiped out. They are relatively inexpensive to replace.

Never mind looks like the DS comes with new u-joints. Didn't see that at first.

 

[fobra559]

Never mind looks like the DS comes with new u-joints. Didn't see that at first.

Good Luck man It should be a nice addition to your gears.