Vortech Water Pump Pulley....Question!

[94GTLaserRC]

When Joe and I did our Vortechs, we did not have the new kits that included the WPP supplied by Vortech. Therefore we both used the WPP off the Foxes, which are smaller and allow clearance. I was curious as to the size of the WPP supplied by Vortech, If anyone has a pic of one either on OR off the car, and/or if you have a link to where I can get one if needed (I couldnt find it on Vortech's site)

Thanks
RC

 

[FlyBy763]

Ill let you know in a week or so when I get mine!

 

[94GTLaserRC]

Ill let you know in a week or so when I get mine!

Ok then, mark this thread.

Anyone else? JR, Kevin, Troy, Shaun????

 

[BlueOvalStangGT]

Sorry man, I have the Cobra one as well.

 

[YEAHLOH95]

i won't be home til tomorrow but i can let you know then. it is smaller than the stock one i'm sure of that, its like an over drive instead of an under drive one . i am going out on a limb and saying its about 4 inches in dia. i'll tell you for sure tomorrow. :OT: any one know the bolt size i need to get some stainless bolts to hold that thing on the stock ones aren't cutting it anymore.

Troy

 

[S/CBlack95GT]

I dont have a pic of mine off hand, but I can tell you that I can't get my finger between the water pump pulley and the crank pulley. If I remember right the vortech pulley is slightly smaller than the stock one. Just small enough to allow for clearance.

 

[94GTLaserRC]

Hahah Kevin...you did the same thing. I had my Stock WPP chromed, only to find it didnt fit at the time. I have the Fox one which seems much smaller. Im just curious as to the difference between the Fox one and the Vortech one.

Thanks for the info...If you find a pic or link please post.
RC

 

[94TURBO5 O]

I sold mine when I took it off. I think it's the same size as an 93 Cobra pulley.

 

[94TURBO5 O]

 

[94GTLaserRC]

Maybe it's just hard to tell from the angle, but it looks like the one in your pic is larger JR.

BTW...I should have bought your VOrtech chrome pulley

Do you get those from Vortech too?

RC

 

[94TURBO5 O]

I bought the blower pulley from SCH Racing. They have them in all sizes.

 

[94GTLaserRC]

I bought the blower pulley from SCH Racing. They have them in all sizes.

I went to the website, and it's just a forum....it's not a place to buy parts
RC

 

[YEAHLOH95]

i just pulled my pulley off its 4.5 inches so my guess wasn't too far off .i had to take it off to repollish my wp.

 

[94TURBO5 O]

I think they stopped production a while back.