Vt stage one cams and tune...question

Mustanggt108

New Member
Sep 23, 2005
221
0
0
if i get the VT stage one cams.I get around 22rwhp withought a tune .and could see around 30rwhp with a tune as i've heard.My question is ...with a tune what parameters change??..like fuel , air..etc
what do you increase or decrease??
One more thing.Will a mail tune for those cams be good enough withought getting a dyno tune?
 
i assume you already have the cams installed and dynoed to know they get 22hp w/o tune.

on that note i guess its possible to get close to 30 with it tuned. yea they will mess with the a/f ratio.

i dont think mail order will do the trick of getting you 30 hp out of them, if anything a dyno tune might.
 
deftsound said:
not to hijack the thread, but what do you sacrifice in terms of drivability if you put new set of stage one cams in with a tune?
I have the stage II's,and have no drivability issues at all.I wouldn't worry to much about it.Once you have a good tune,you would be amazed how it will run,without sacraficing everyday drivability :nice: .The Mod motors run so much smoother then the pushrod engines when cammed,i fine anyways :shrug: .It's just like gears,everyone is scared to make the jump,but when they finally do,they go..."oh shat,why did i wait so long." :D
 
The stg 1s just have some jerking at LOW RPM with your foot off the gas and in gear. I got about 24RWHP from the cams alone. 33ish from cams, 75MM TB, and JLT RAI. And my car was tuned by Tim barth @ MPH.
STG 2s will drop some drivability due to the loss of lowend torque over the stg 1s/stock. But if your car is untuned before stg 2s and then tuned after stg 2s, I doubt you would see any difference till about 3500...then all heck would break loose lol. I need to get my vid up of my car with open headers, sounds like a race car....felt like I was at the track when taking the vid lol.