Hello guys.
I want to install my autometer water temp gauge. I have a extra aluminum crossover that I have drilled and taped for the sensor. I then went to go replace the crossover. I was looking at lower intake manifold and it looks like I have to remove the whole lower intake. Is this true? I have done this in the past due to NITROUS BACKFIRE and I had to replace my plastic manifold, not hard but a pain. Do you guys now of anyway of removing this crossover without removing the whole intake? Because I will have to now drain the coolant way down. Also how much and what kind of antifreeze do you guys use? Is there something easier to do or a different place to install that is easier?
Thanks for the help in advanced
David
I want to install my autometer water temp gauge. I have a extra aluminum crossover that I have drilled and taped for the sensor. I then went to go replace the crossover. I was looking at lower intake manifold and it looks like I have to remove the whole lower intake. Is this true? I have done this in the past due to NITROUS BACKFIRE and I had to replace my plastic manifold, not hard but a pain. Do you guys now of anyway of removing this crossover without removing the whole intake? Because I will have to now drain the coolant way down. Also how much and what kind of antifreeze do you guys use? Is there something easier to do or a different place to install that is easier?
Thanks for the help in advanced
David