• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

weird noise when i release clutch

  • Thread starter Thread starter rogerz
  • Start date Start date May 6, 2012

rogerz

New Member
May 6, 2012
6
0
1
phoenix az
May 6, 2012
#1
  • May 6, 2012
  • #1
i have a 87 5.0 gt and i noticed that when i release the clutch through all gears it makes a weird clanking noise.and it only happens right as i begin to roll or just shift driving down the street. i have no idea what is causing this if anyone can help or point me in the direction of someone who can id appreciate it
 

Vaz88GT

Active Member
Apr 8, 2012
264
27
38
May 6, 2012
#2
  • May 6, 2012
  • #2
Probably your U joint, mine does it.
 

mob

the guy who hits on his mom
20+ Year Stangneter
Oct 3, 2003
2,566
136
104
Dallas, TX
May 7, 2012
#3
  • May 7, 2012
  • #3
I had this issue for a while also, I actually felt the clunck through the pedal though, just went away after a while never found out what it was.
 

Vaz88GT

Active Member
Apr 8, 2012
264
27
38
May 7, 2012
#4
  • May 7, 2012
  • #4
mob said:
I had this issue for a while also, I actually felt the clunck through the pedal though, just went away after a while never found out what it was.
Click to expand...

Dead animal
 

rogerz

New Member
May 6, 2012
6
0
1
phoenix az
May 7, 2012
#5
  • May 7, 2012
  • #5
yeah i have had a few people tell me it was the u-joints and a few others say it was motor and trans mounts.
 

Vaz88GT

Active Member
Apr 8, 2012
264
27
38
May 7, 2012
#6
  • May 7, 2012
  • #6
Also the clunk can be stress on your drivetrain, i know its loud but try shifting at higher rpms and slower

*edit* not trying to sound like a ass, im sure you can drive better than me
 

rogerz

New Member
May 6, 2012
6
0
1
phoenix az
May 7, 2012
#7
  • May 7, 2012
  • #7
yes even when i am shifting at high rpms it still does it, it is a lot less loud at higher rpms i think due to the engine screaming but it is still there
 

Gearbanger 101

Straight Outta Locash
20+ Year Stangneter
Aug 10, 2002
9,457
1,377
234
Ontario, Canada
May 7, 2012
#8
  • May 7, 2012
  • #8
I'll throw clutch throw out bearing into the mix. Could even be haning up on the bearing retainer if it's got some wear on it.
 

Justin81

New Member
Jan 9, 2012
22
0
1
Pittsburgh
May 7, 2012
#9
  • May 7, 2012
  • #9
That sounds like the same problem I'm having. I installed a new clutch over the winter and don't remember hearing that sound before that. That's leading me to believe that it might be the throwout or pilot bearing although they're brand new. At first I thought it was just my x pipe rattling off my trans crossmember. After clearancing that the sound remained. It seems to come and go. Everytime I pull the car up on ramps I can never get it to duplicate the noise.
 

Noobz347

Stangnet Facilities Maint Tech... Er... Janitor
Admin Dude
Jan 4, 1985
42,977
21,159
234
Box behind Walmart
May 7, 2012
#10
  • May 7, 2012
  • #10
rogerz said:
yeah i have had a few people tell me it was the u-joints and a few others say it was motor and trans mounts.
Click to expand...

rogerz said:
yes even when i am shifting at high rpms it still does it, it is a lot less loud at higher rpms i think due to the engine screaming but it is still there
Click to expand...

Had this happen before. Loosen up trans mount bolts, and motor mount bolts. Start the car and do a slow run around the block (let stuff reseat if it's going to). If there's no change then look at U-joints and this:

Gearbanger 101 said:
I'll throw clutch throw out bearing into the mix. Could even be haning up on the bearing retainer if it's got some wear on it.
Click to expand...
 

Vaz88GT

Active Member
Apr 8, 2012
264
27
38
May 8, 2012
#11
  • May 8, 2012
  • #11
Just jack up the car and check it out. I just finally did mine and my rear u joint was so bad the driveshaft was hanging and inch low
 
You must log in or register to reply here.

Similar threads

S
  • Locked
Drivetrain Adjustable clutch cable questions
  • Scott_S
  • Oct 31, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
402
Fox 5.0 Mustang Tech Oct 31, 2025
Noobz347
S
Fuel ‘88 GT Runs Rich Cold — Fixes Itself When I Unplug Sensors (ECT, MAF, O2, etc.)
  • Sufarry
  • Nov 6, 2025
  • Fox 5.0 Mustang Tech
Replies
12
Views
778
Fox 5.0 Mustang Tech Nov 9, 2025
Mustang5L5
2008 Mustang Bullitt stuck in Fifth gear
  • Jester67
  • Jul 15, 2025
  • 2005 - 2014 S-197 Mustang -General/Talk-
Replies
10
Views
365
2005 - 2014 S-197 Mustang -General/Talk- May 27, 2026
Jester67
Fox Suspensión Noise
  • PonyGTrider
  • Nov 24, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
11
Views
356
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 8, 2026
PonyGTrider
K
TKX Transmission Shifting Problem
  • KWC156
  • Jun 23, 2025
  • Other Auto Tech
  • 2
Replies
21
Views
2K
Other Auto Tech Jun 13, 2026
427nostang
4
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?