yeah i need a temp gun to shoot at it to figure it out. might look into a police fan clutch. mine used to only run 2 or 3 ticks up on the temp guage till i fixed the temp sensor
TenorPlayinGuy
Founding Member
Made mine blow cold air through the vents again!
Please tell me your secret! Just kidding I would have to have a/c for my car to blow cold. I'd be happy with heat also.
1989DropTop
Active Member
Installed Oil Pressure Gauge, Water temp Gauge and Volt Gauge and ordered a bunch of parts from Cj's as they have free shipping this weekend and 20%off Sale!
FoxVerts
New Member
stangrod2000
Member
93project
Active Member
I installed new rear upper and lower control arms since I grenanded my old Mac ones. Car feels SOOO. Much better now
mg92calypso
Member
FINALLY got the hood lines looking good. gotta love fiberglass! and she is finally burried in primer. running a little behind my original schedule but will be ready for paint in a couple of days.
FoxVerts
New Member
I installed some GTS smoked covers on the under bumper wig-wag driving lights. I also talked to the original owner who bought the SSP at auction in 1993 and found out it has had the factory exhaust replaced with NOS, had the factory 2:73 gears replaced with 3:55 set, had the factory heater core replaced, and that it was repainted in 1997.
I helped the AAA guy load it onto the back of his tow truck, then I helped him unload it into my garage.
Popped my alternator charge cable fuse, and it is 100% my own damn fault.
Popped my alternator charge cable fuse, and it is 100% my own damn fault.
FoxVerts
New Member
Was a good week for my white 90.
I got a used IAC idle plate ($10) the car idles like a champ now, so happy.
I got a clutch quadrant and firewall adjuster as a freebie from my homies.
I just got home with a new pro 5.0 for 100 bucks for the 3550, it is missing the stop bolts but many say not to use the stops. Not sure what I think about not using the shifter stops... may grab some bolts before I install it tomorrow.
View attachment 186950
Got the gears, gears install kit and bearing ready to go for the 3.55 install next week.
Just need some non stock LCA's an I will call it good....
TKO 3550 have built in stops in the trans,i dont use my stops on my tri-ax shifter and no problems yet! peace
john
ReefBlueHatch
Active Member
Riverart
Well-Known Member
Similar threads
- Replies
- 9
- Views
- 341
- Replies
- 19
- Views
- 903
- Replies
- 19
- Views
- 1K