what kind of intake do you recomend for a blown 306?
- Thread starter looking4stang
- Start date
cardudeusa
Founding Member
I think the r is more for race only are you going to be street driving this car at all? IMO go with the street heat if its going to be daily driven.
mike keirstead
New Member
is this motor going in a F150 4x4 with 35's then I would say not a R. But if you put it in a Roadster that weights 1200 pounds maybe a R with trick flow R heads, but if you have E7's and are putting it in a swamp buggy you might want to think about a hogan sheet metal intake oh and of course all that depends on the cam? 
TIMMY2734
Founding Member
What is the rpm range of your cam? If you had a stroker, id go wiht the r series. Based on the limited info, id look at the track heat, the holley and the edelbrock rpm
HO93LX302
Founding Member
I would go with the TFS-R with the 306.. I'm gonna get it for mine once my long rod 306 is built.. Well either the R or the new intake trick flow came out with, but I haven't seen an numbers on it yet.. These type of intakes make more power in higher rpm's so if you are going to rev the engine past 6,000 say like close to 7,000 then they will be good.. Either that or the Victor intake from Edlebrock
tvmango
New Member
tfs track heat, or holley systemax,, track heat's alot cheaper though,, you need to keep as much low end as possible, don't go with the r......
Similar threads
