When should I replace O2 Sensor?

glowstang93

20+ Year Stangneter :roc</strong><span class=
Feb 9, 2003
853
8
39
Illinois
This is on a 4 banger, but I wouldn't think it would be too much different. So here is my question I've got 85,000 miles on her and still the original O2 sensor. Don't notice any hesitating, idle sometimes is a litle rough, but not dying. When should you replace the O2 sensor? A certain mileage?

Thanks
 
Anthony, I might give the sensor a quick check with your meter. I do this when I'm unsure of how they're doing. I look for it to toggle between 0.05 and 0.95 Volts (or somewhere close to both of those) atleast once a second.

It's pretty apparent when an O2 has taken a dump - the amplitude is gone and the frequency might be pretty slow. Otherwise, you might be able to leave well enough alone.

Good luck bud.
BTW, the car looked good all shined up. :nice:
 
Thanks JT

Ok, you knew this question was coming next. To hook up a meter to it, do you unplug the sensor plug , put the meter negative on ground and the positive on the sensor wire that is not a dark color (ground)?

It doesn't look too hard to replace. I was thinking it was on the topside of the manifold, but its actually pointing toward the ground. So she will have to be jacked up to get to it easily.

Man, a lift would be nice right now. I could change the oil, o2 sensor, transmission filter/fluid, fuel filter and differential fluid all in one lift:D

So when the O2 goes out does go out, does the engine keep running, but just poorly?
 
When I check the O2 voltages in real time (car running), I simply gain access to the O2 signal wire (I'm unsure of what color or pin it is on a 4 banger). This can be done in the kick panel where the EEC harness connects to the computer or at the O2's connector. If doing the latter, I'd recommend a jumper harness so you are not lying underneath an idling car. The kick panel might be the easiest.

Anyhow, you leave all harnesses connected and see how the O2 does in it's normal dynamic. No need to unplug anything.

Good luck bud.
 
Thanks JT.

I talked to my friend/mechanic. He basically said what you had said. If it ain't broke, don't fix it. He said the the CEL will come on if it is not working correctly. So , I'm going to leave well enough alone for now. My luck, I would take it out and the threads would be rusted or stripped and I would have to buy a new manifold :lol: