Where do buy turndowns?

[jmd2914]

ok, i want to put dumps on my car and i know this is going to be a really dumb question, but where can i find some good turndowns? cuz ive looked in summit and i dont really see anything that quite fits what im looking for.

 

[Roland69]

any muffler shop can make them in like 5 min's if they don't have any there. Mine all I did was bend a bend a piece of pipe till it was a U and then cut it in half.

 

[Brians89GT]

any where you can get them at walmart for like 10 bucks a piece they are made by Tuned and they are stainless

 

[mbsprinks281]

Fab em'

 

[bluevenom867]

You can look on Jegs web site,they got the Flowmaster "scavinger" turn downs.

There nice (we got a set),but pricy for a piece of formed aluminumized steel.

 

[95GTV8]

if i could find a way to ripe mine off i'd give em to you. I think the previous owner welded mine on

 

[jmd2914]

i dont think im gonna weld them on, I'm gonna use clamps that way i can put my tails back on if i want to

 

[Deleted member 87397]

Just buy some MAC pro dumps. Turndowns included! Sorry, I couldn't resist being a smart ass.

 

[bluevenom867]

i dont think im gonna weld them on, I'm gonna use clamps that way i can put my tails back on if i want to

Make sure there good clap,I tired to use some,but the bolt almost broke!

So I left the clamps on and just had a couple of small tac welds to hold them on.

 

[BaXTeR3221]

I would just go to a local midas or something. Shouldn't cost much and they'd get em done in like 20mins.

 

[88Stangboy]

I just got some of that 3 foot long exhaust tubbing from advanced and bent it with a pipe bender in my dads shop and welded them on there.

 

[jmd2914]

ok how much would it cost to have my local shop cut of my tail pipes right after the muffler and have them weld on dumps? and do you guys think that with my combo dumps will be too loud?

 

[Roland69]

It will be loud and ressonate like a muther efr

 

[Euphoric306]

yea thatll be pretty loud

it was 90 bucks for a muffler shop to cut off my tails and old mufflers, weld in my slp's and dumps



any muffler shop should have dumps laying around, but id suggest mandrel bent ones