I agree. You probably need them anyway and get the ones for a 94-95. Or when they do go bad get them - then you can chunk the shim. And that is .330 shim not .030 . It was prob a typo but I want you to make sure you get the right one in case it wasn't a typotrents99 said:On an '89 it's probably not a bad idea to replace the ball joints anyways. Mine were toast.
ALMOST STOCK said:Just a suggestion if you haven’t already purchased the spacer and that is you could also go to just about any metal fabrication shop and have them cut you 2 pieces from there 1-1/4 round stock with a 5/8 hole in the center hole in the center at the .330 or 5/16 in thickness.
That's what I did and it cost me nothing because they said they’d catch me on my next purchase.
View attachment 506497
howard99 said:I just used washers. I actually welded mine together then used a grinder to get to the right size.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?