whistling noise?

jcw88

Never played w/ it before so i'm still a virgin!
Mar 20, 2007
53
0
0
fernandina, fl
i replace my upper and lower intake manifolds and upped my injectors to 24lbs. i'm now getting a loud whislting noise coming from either the idl control motor or the egr spacer and throttle body. i had a vacuum leak in the egr spacer gasket before and have replace them with a 75mm gasket, my throttle body and egr spacer is only a 70mm the local shop said this would be fine but not sure whats going on? maybe my idle control motor is bad??
 
first, your iac isn't a motor. it's an air bypass so your car can idle with the throttle body shut. and that could be the problem. clean it and see. as far as the gasket, that could cause it as well. since the gasket opening is larger than the bore, there's a gap between the throttle body and egr spacer that the wind might be catching, causing the whistle. shouldn't be a problem, aside from having that annoying whistle.
 
i understand what your saying about the gasket size but my car doesn't want to idle. at least after it has ran for a few mins. i crank it up it runs good the noise starts then after a few mins it shuts off. i have no clue. i replaced my lower intake and didn't use rtv on the cyclinder head side just on the front and back of the block. maybe i'm getting a vacuum from there?
 
get a vacuum tester and make sure your vacuum is good... if it is ok.. adjust the idle air screw on the bottom of the throttle body.. with the iac unplugged... should idle at 600 unplugged... once you get it down to 600... readjust your tps with key at on position... so the voltage reads between .6 and .9.. make sure the engine is warm though before doing this... the disconnect your battery cable for about 10 minutes... then restart the car with iac plugged in.. and the comp will have to relearn but it should idle better... about the whistling could be the gasket.. if it is still idling bad the iac motor could be bad..