I'm doing a gasket match on a performer lower intake to a fel-pro 1250. I was looking at the injector holes inside the runners and was wondering if i could shave them down at all. They are kind of in the way and i'm not sure if i will hurt anything or not.
I ported my Performer lower to my 1250s & intake ports on the AFR 165s. I pretty much matched up everything but decided to leave the injector bosses alone and kinda worked around them much as I could.
You can take them down (or up depending on point of reference) as long as you keep an eye on measuring how thin the runner walls get at critical points.