will bullits fit foxbody

airbag said:

i have a 92 gt 97 rear disk 5 lug can i fit stock 17x8 bullit wheels without rolling rear wheelwell lips, what front rotors can i buy to convert the front to 5 lug

Click to expand...

Mustang5L5 said:

Yes 17x8 bullitts will fit fine with the '97 width rear end.

Up front, you can make them work on the 5-lug conversion rotors, but you will not be able to run the center cap.

SN95 front setup is the best way to go.

Click to expand...

tjm73 said:

Loosly related question.......... How far out does the grease cap stick, preventing the center cap from being used?

Click to expand...

2002BLGT said:

I used a 7/16th Mr gasket wheel spacer and if they made it could have probably used a 3/8th one .....but I didnt have to but did put longer studs in because with the stock studs I didnt have a lot of threads to bite to .......and since the parts store didnt have a stud that had the same knurl and just longer I had to get some slightly smaller that spun in the rotor and broke out the welder and welded them on the back side to keep them from pushing back in the rotor and spinning as I tightened the lugs up ......took a little time but works good

Click to expand...

fate5.0 said:

So are the 94-95 spindles, hubs and rotors the same for a V6 to a GT?

Click to expand...