Will New Edge axles work on our cars?

mustanggt94 · May 3, 2007

I found out that the axles on our cars are 29.969" and the one from the New Edge models are 30.688". Though I see the Foxes are 29.188", so the difference is less betewen the New Edge and SN-95 than the difference between the SN-95 and Foxes (and I know the Foxes can use our axles).

I'm asking because I can get a good deal on some Moser axles that are for a New Edge.

The Green GT · May 3, 2007

Well you can push them in and out when you have the rear end out.

As far as them being safe to use, I couldnt tell you, but im sure someone can.

go-stang5.0 · May 4, 2007

NEW EDGE??? As in the new Ford Edge crossover suv doohicky?? What am I missing here?

BlownFiveLiter · May 4, 2007

New Edge refers to the 99-04 SN95 Mustangs. I don't see why you couldn't use those axles though. They'll just be a little longer.

SublimeRT · May 4, 2007

94-98 rears are 3/4" more narrow per side....1.5" overall more narrow....than 99-04 rears. They won't work.

divit250r · May 4, 2007

SublimeRT said:
94-98 rears are 3/4" more narrow per side....1.5" overall more narrow....than 99-04 rears. They won't work.

+1

I don't think you'd be able to make the rear brakes work at the least. If the housing is the same, then you'd probably just need caliper brackets from a 99-04 along with the axles. If the housing is wider as well, then forget it.

Scott

mustanggt94 · May 4, 2007

divit250r said:
+1

I don't think you'd be able to make the rear brakes work at the least. If the housing is the same, then you'd probably just need caliper brackets from a 99-04 along with the axles. If the housing is wider as well, then forget it.

Scott

Yeah after thinking about it that was my concern too. Does anyone know the diminsions of the 99-04's rear ends? It might be worth hunting down the brackets for the brakes if that is the case.

Oh and anyone know about how much it runs to have the axles cut down? Moser advertises that they will shorten your axles if you ever decide to narrow your rear end. That may be worth it too, dunno.

1TallMF · May 4, 2007

I'm pretty sure the axle tubes on the New Edge are longer than ours, not the brake brakets themselves. I bet you might even be able to find a used axle assembly out of a 99-04 for cheaper than it would cost to shorten the Moser ones, but for that total cost you would probably be better-off just getting moser shafts for the '94-'98 axle, unless your getting the NewEdge ones for next to nothing...

68coupe1 · May 4, 2007

The whole housing is longer. I tried to do this swap once. Didnt work. Brake brackets are the same.

Will New Edge axles work on our cars?

mustanggt94

Member

The Green GT

No 13 year olds are safe around me.

go-stang5.0

New Member

BlownFiveLiter

have car, will race....wait, it doesn't run

SublimeRT

Member

divit250r

Member

mustanggt94

Member

1TallMF

New Member

68coupe1

New Member

Similar threads

Will New Edge axles work on our cars?

Member

No 13 year olds are safe around me.

New Member

have car, will race....wait, it doesn't run

Member

Member

Member

New Member

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency