I had some weird off and on problems with the turnsignals and wipers.
After searching High and Low and inbetween, Tracing thru the looms and halfway tearing the thing apart.
I think i found the problems,
The fuse panel.
Seems that even with good fuses and tight connection,[even behind the panel]
that the inside where the fuse is held had glazed over with a slight non- conductive film.
Even with checking for power flow with a meter and it showing voltage, they sometimes would not work the accessorys.
By using some 320 grit sandpaper and cleaning all of the inner part of the fuse holders,
Just a little insight when you start to have the gremlins attack.
PB
After searching High and Low and inbetween, Tracing thru the looms and halfway tearing the thing apart.
I think i found the problems,
The fuse panel.
Seems that even with good fuses and tight connection,[even behind the panel]
that the inside where the fuse is held had glazed over with a slight non- conductive film.
Even with checking for power flow with a meter and it showing voltage, they sometimes would not work the accessorys.
By using some 320 grit sandpaper and cleaning all of the inner part of the fuse holders,
Just a little insight when you start to have the gremlins attack.
PB